ICC Vapor Recovery 2| 60 Questions| With
Complete Solutions
After backfilling the vapor return and vent lines, the maximum pressure drop through the system shall not exceed ________at 60 cubic feet per hour as determined by TP-201.4, Dynamic Backpressure.
a. 0.75 inches WC
b. 0.5 inches WC
c. 0.32 inches WC
d. 0.55 inches WC correct answer: c. 0.5 inches WC
CARB's most recent vapor recovery regulations are known as:
a. EVR (enhanced vapor recovery)
b. CVR (California vapor recovery)
c. PVR (protective vapor recovery)
d. ORVR (onboard refueling vapor recovery) correct answer: a. EVR (enhanced vapor recovery)
A valve installed in a motor-vehicle fueling hose designed to separate with little or no product
a. breakaway
b. hose clamp
c. sheer valve
d. flow limiter correct answer: a. breakaway A Gilbarco Vapor VAC/OPW Vapor Saver system is consdered to have a vapor recovery equipment defect (VRED) if the vapor escape guard on an OPW 12 VW nozzle is missing or damaged on at least ____ % of the circumference of the device.
a. 25
b. 50
c. 75
d. 100 correct answer: c. 75
The two point Phase I vapor recovery system requires that a separate vapor recovery riser pipe be installed in the tank and be equipped with a: a. drop tube
b. locking block valve
c. pressure/vacuum vent
d. vapor recovery adaptor correct answer: d. vapor recovery adaptor....
When removing liquid from a sump or spill bucket and the liquid contains fuel, it must be:
a. managed as hazardous waste
b. pumped into a bucket to evaporate
c. scooped or balled onto the concrete pad
d. put it in a sealed container and put into a dump correct answer: a. managed as hazardous waste One of the approved methods of overfill prevention is to have an
overfill device that will automatically shut off the fill to the tank when the tank is at a maximum of ____ % full.
a. 80
b. 90
c. 95
d. 99 correct answer: c. 95
What is the appropriate way to clean up a small spill of gasoline?
a. Allow product to evaporate from the area.
b. Wash the spilled product from the area with water.
c. Apply absorbent to the affected area to prevent evaporation.
d. Apply absorbent to the affected area, then remove and dispose
of absorbent in accordance with applicable requirements. correct
answer: d. Apply absorbent to the affected area, then remove and dispose of absorbent in accordance with applicable requirements.
Which of the following is not an overfill prevention device?
a. ball float
b. spill bucket
c. tank overfill alarm
d. drop tube flapper valve correct answer: b. spill bucket
According to PEI RP300, a combustible gas indicator can be used to:
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Demetrius. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for £10.37. You're not tied to anything after your purchase.