R 410a Study guides, Revision notes & Summaries

When a new system has been assembled, the first thing to do is? Pressurize the system with an inert gas & leak check. After installation of a field-piped R-410A split heat pulp, the unit should first be? Pressurized with nitrogen then leak checked. The EPA regulations require that any appliances containing more than 50 pounds of refrigerant (except for commercial & industrial process refrigeration) must be repaired when the leak rate exceeds _________ of the charge per year? 15%

EPA SECTION 608 CORE (2021-2022 revision) A disposable cylinder should be reduced to what pressure before scrapping? a. 0 psig b. 20 psig c. 50 psig d. 80 psig A major system repair is being performed on a R-22 appliance. What CANNOT be done to recharge the appliance? a. Add R-22 after the repair is complete. b. Retrofit the unit to R-407C. c. Use recovered or recycled R-22 from the same owner. d. Top off the unit with R-410a. A refillable cylinder must not be filled above what ...

EPA 608 (TYPE II) Exam COMPLETE SOLUTION ( A+ GRADED 100% VERIFIED) When a new system has been assembled, the first thing to do is? - ANS Pressurize the system with an inert gas & leak check. After installation of a field-piped R-410A split heat pulp, the unit should first be? - ANS Pressurized with nitrogen then leak checked. The EPA regulations require that any appliances containing more than 50 pounds of refrigerant (except for commercial & industrial process refrigeration) mus...

EPA 608 Type 3 Questions and Answers Already Passed On low pressure chillers, moisture typically enters the refrigerant system through air leaks from areas with gaskets or fittings The maximum test pressure for leak testing a low pressure centrifugal is: 10 psig Leak test and repair the chiller to reduce refrigerant loss from a pruge unit on CFC-11 chiller ... A hydrostatic tube test kit is used to: determine if a tube leaks Commercial and industrial process refrigeration systems must be rep...

Refrigeration technicians who violate the Clean Air Act can: - - Correct answer-Lose their EPA certification, be fined, be required to appear in Federal court. After 1995, any supplies of CFC refrigerants to service existing units in the USA can only come from: - - Correct answer-recovery and recycling. Refrigerant that is recovered can be returned to: - - Correct answer-the same system or other systems owned by the same person without restriction. Refrigerant can not be called "reclaimed...

Recovery cylinders used with R-410A must have a DOT rating of: - either "DOT 4BA 400" or "DOT 4BW 400" A system using R-410A refrigerant has bubbles in the sight glass. Technician A says that the system must be low on refrigerant. Technician B says that the bubbles could be caused by the blended refrigerant flashing in the increased volume of the sight glass. Who is correct? - Technician B only When charging a R-410A system that uses a thermostatic expansion valve, proper charge can be...

EPA 608 Type 1 Questions and Answers 100% Pass Recovery equipemnt used for the service or repair of small appliances must be certified by an EPA approved lab if the recovery equipment was made after November 15, 1993 Recovery devices made before 11-15-93 and are used for recovery of refrigerant from small appliances must be capable of: recovering 80% of the refrigerant whether or not the compressor is operating or achieving a 4 inch vacuum under conditions of ARI 740-1993 EPA's definition of...

EPA Type 2 Questions and Answers Already Graded A Heat pumps that have been retrofitted from R22 to R407C should be leak checked with: pressurized nitrogen When a new system has been assembled, the first thing to do is: pressurize the system with inert gas and leak check EPA regulations require that leaking commercial or industrial process refrigeration equipment must be repaired when the leak rate exceeds______ of the charge per year. 35% Prior to replacing the condenser coil in a high pres...

EPA 608 Practice exam type 1 solved correctly The sale of reclaimed CFC, HCFC, HFC, and HFO refrigerants is_______. Restricted to technicians who are EPA certified and refrigerant recovery A small Pliance is defined as a system that is Manufactured, fully charged, and hermetically sealed in a factory with a charge of 5 pounds or less A __________ recovery device can be use for type 1 small appliance applications or type 2 applications if the total charge is below 15 pounds. System dependent Y...

R-410A safety & Training Exam 2024...