Series circuit Study guides, Class notes & Summaries

NEIEP 300 2023 Exam Questions and Correct Answers How should ammeters be used to take measurements in a circuit - ANSWER Connected in series with the circuit What will happen to the current in a circuit if the resistance is doubled - ANSWER Current will be halved How do you measure voltage in a circuit - ANSWER Meter must be parallel with volt being measured What is the outermost shell of an atom called - ANSWER Valence shell The Nucleus of...

When connecting a 3-phase motor the three lines (T1,T2 and T3) are usually connected to __________. - L1, L2, and L3 Electricians use __________ to prevent damage to electrical wiring running to the machine. - rigid and flexible conduit When the wire or foil strip inside a fuse melts, the fuse is said to be __________. - blown The difference between a fuse and a circuit breaker is __________. - circuit breakers can be reset and used again The amount two electrical...

NEIEP 600 Final Exam Version 2 (Latest 2024 / 2025 Update) Questions and Verified Answers | 100% Correct | Grade A Q: What is the time constant for a circuit with 150 K ohms and 2 microfarad capacitor? (TC = R x C) Answer: 0.3 seconds Q: How long will it take for this capacitor to be considered fully charged? Answer: 1.5 seconds Q: The voltage required to cause conduction across the junction in a germa- nium diode is? Answer: 0.3 Q: A 1.5 volt 8 milliamp light emitting diode needs to be operated...

CCDS IBHRE LATEST UPDATE ALREADY GRADED A Rheobase the lowest point on a strength duration curve at an infinitely long pulse duration Chronaxie time the pulse width at twice the rheobase value. It approximates the most efficient stimulation pulse duration Charge (formula) Charge= I(current) x T(time) Furman's formula Energy(microjoules)= I(current)xV(voltage)xT(pulse width) Ohms law formula Voltage(electromotive force)= I(current/flow of electrons) x R(resistance to current flow in ohms) F...

NEIEP 700 Final Exam Version 2 (Latest 2023/ 2024 Update) Questions and Verified Answers| 100% Correct| Grade A Q: What is the primary reason AC relays hum or chatter? Answer: AC cycle reversal Q: Which of the following best describes the contact rating of a magnetic switch? Answer: The maximum voltage and current that can be safely interrupted Q: How can you reduce contact arcing on plug-in relay contacts? Answer: Wire two contacts of the same relay in series ...

NEIEP 700 Final Exam Version 2 (Latest 2024 / 2025 Update) Questions and Verified Answers | 100% Correct | Grade A Q: What is the primary reason AC relays hum or chatter? Answer: AC cycle reversal Q: Which of the following best describes the contact rating of a magnetic switch? Answer: The maximum voltage and current that can be safely interrupted Q: How can you reduce contact arcing on plug-in relay contacts? Answer: Wire two contacts of the same relay in series Q: How are latching relays reset...

What is the result if the neutral wire becomes open on a multiwire circuit having unequal loads? Select one: a. The load of higher resistance would overheat and probably be damaged. b. The load of lesser resistance would overheat and probably be damaged. c. No effect until one load is turned off or opens. d. No effect. The load of higher resistance would overheat and probably be damaged. Refer to Figure 128.202. ___ volts are applied across the water heater element. S...

Unit 15: Electrical Circuits and their Applications A: Understand electrical symbols, units, definitions, relationships and properties of circuit components for use in the construction of circuits. B: Construct series and parallel circuits for use in standard electrical applications and measure electrical values. BTEC Level 3 Extended Diploma in Applied Science At Distinction grade level. With hand drawn graphs and with my OWN research (plagiarism-free). Please message me if you have any doub...

An AC circuit consists only of a pure inductance and a power source. The relationship between the voltage and the current in this circuit is that the correct answer: current lags the voltage The power factor of a load is equal to the ____________ power divided by the ____________ power. correct answer: True ; apparent A 10-ohms and 20-ohms resistor are connected in parallel. The total line current drawn by this parallel combination is 30 amps. Under these conditions, the line voltage wil...

1. A contractor wants to raise the car speed from 100fpm to 125fpm, it currently has a 12" sheave. What sheave is required?: Diam=12" 12/4=3" 25fpm=3" 100fpm + 25fpm= 12"+3"= 15" sheave 2. A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do?: Replace it with a larger MOV 3. On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue?: Suicide Circuit 4. You have an old DC ...

Fire Investigator TCFP Exam| 500+ Practice Questions and Verified Answers| 2023/ 2024 Update Q: What is the ability of a structural assembly to maintain its load-bearing capacity and structural integrity under fire conditions Answer: A.) Fire resistance Q: What would most likely need to happen for the fuel-gas product to ignite in the piping system Answer: C.) Leak from the system Q: What can the fire investigator conclude when the electrical safety devices operated ...