Hvac Study guides, Class notes & Summaries

ASD Exam Questions With 100% Correct Answers 2023 Category 1 - Correct Answer-Category of Water that originates from sanitary water source (Clean) Catetroy 2 - Correct Answer-Category of Water that is contaminated; may cause discomfort or sickness (Grey) Category 3 - Correct Answer-Category of Water that is grossly contaminated; includes toxins, pathogens Special Situation - Correct Answer-Regulated or hazardous materials Class 1 - Correct Answer-Class of water that has least amount...

HVAC JOURNEYMAN EXAM AND PREP TEST EXAM 250 QUESTIONS AND CORRECT DETAILED ANSWERS TOP RATED VERSION FOR ALREADY A GRADED WITH EXPERT FEEDBACK|BRAND NEW!|REVISED

On an R-22 system, line diameters and lengths are typically specified for a vapor pressure drop that does not exceed what? CORRECT ANSWER 6-7PSI or 6F What is the primary purpose of using flux when soldering copper or brass parts? CORRECT ANSWER Prevent Oxidation The water that results from a defrost cycle of an air to air heat pump(runoff) must? CORRECT ANSWER Drain off and away from the outdoor coil. Why must the runoff be drained off and away from the outdoor coil? CORRECT ANSWER Exc...

HVAC Excellence - ELECTRICITY Exam 2024 Guide with complete solution

Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than the air test. - Answer B. Fitting shall be replaced or repaired and retested. UMC Section 1316.4.3 Every absorption refrigerating system supported from the ground shall rest on a concrete slab extending not less than _____ the adjoining ground level.(A) 3 inches below(B) 3 inches above (C) 6 inches below(...

When using a low voltage T-stat for heating and cooling, when would there be a jumper between Rh and Rc? Select one: a. When using a single transformer system b. When heating with an oil boiler c. When heating with a gas boiler d. When using a two transformer system - Answer-A) When Using a single transformer system Digital thermostats usually display temperature, time of day, programming and operating status. Select one: True False - Answer-True With the fan switch in the on position...

BOMA – HVAC QUESTIONS AND ANSWERS 100% PASS Two basic categories of chillers are the compression cycle and absorption The five requirements for comfort are proper temperature, humidity, filtration, and ventilation circulation The primary function of an expansion device is to produce a reduction in the pressure on the liquid refrigerant, regulate the flow of refrigerant into the evaporator, lower the boiling point of the refrigerant far enough below the temperature of the load to g...

HVAC (EPA Certification Exam Section 608) Questions With Verified Solutions | ALREADY PASSED | LATEST REVISED UPDATE What does a metering device do? - ANSWER The metering device causes a reduction in pressure, and therefore a reduction in saturation temperature. What is absorbed in the evaporator? - ANSWER Heat is absorbed in the evaporator. What happens in the evaporator? - ANSWER Heat is absorbed in the evaporator and causes the refrigerant to boil from liquid to vapor. At...

HVAC Journeyman Test UPDATE ACTUAL EXAM ALL QUESTIONS AND CORRECT DETAILED ANSWERS (VERIFIED ANSWERS) 100% PASS SOLUTION /ALREADY GRADED A+

HVAC Air Condition Esco 2023 Exam Questions and Answers Heat which causes a change in temperature of a substance is called - ANS ️️ Sensible Heat Heat added to a substance without a rise in temperature is called - ANS ️️ Latent Heat Heat added to refrigerant in a vapor state after the evaporation process is called - ANS ️️ Superheat A scroll compressor moved refrigerant by means of - ANS ️️ Involute spirals The movement of heat by way of fluid is called - ANS ️️ Conv...