Turbine Study guides, Class notes & Summaries

AMP 221 TURBINE THEORY FINAL EXAM STUDY GUIDE When an engine with a subsonic divergent type inlet duct is running in place at high speed on the ground, the air pressure within the inlet is Positive What will result if an oil filter becomes completely blocked? Oil will flow at the normal rate through the system. Why are turbine engine igniters less susceptible to fouling than reciprocating engine spark plugs? The high-intensity spark cleans the igniter. For what primary purpose is a turb...

Turbine engine test 1 questions and answers with complete solution

turbine engine designs/familiarization | with complete solution 2024/25

1 (8108) - At what point in an axial-flow turbojet engine will the highest gas pressures occur? correct answers C- At the compressor outlet. 2 (8109) - One function of the nozzle diaphragm in a turbine engine is to correct answers C- Direct the flow of gases to strike the turbine blades at the desired angle. 3 (8110) - What is the profile of a turbine engine compressor blade? correct answers B- A reduced blade tip thickness. 4 (8111) - The fan rotational speed of a dual axial compressor...

2 - AMT - Powerplant - Turbine Engines (121) | with complete solution | Latest 2-2024/25

The archmedian screw is pumps material by? A bolt threaded screw in an enclosed cylinder or open trough If material being pumped needs to remain at a certain temperature ________ pipes are used Insulated Centrifugal pumps are good for pumping waste because of Low head pumping requirements and the ability to pass small particles Which is the most well suited pump for pumping high viscosity material? Positive displacement pumps Greases, heavy mastics, cement, and si...

Millwright Level 4 Turbines Exam Questions With Verified Answers 2024/2025 Carbon rings are used to seal the steam within the casing of steam turbines. why is this method effective on impulse type steam turbines? A. low casing pressure B. minimal maintenance C. high shaft surface speeds D. corrosion resistance A. low casing pressure Transpiration is a process of using __________ to cool the turbine blades A. super heated steam B. a watery steam vapor C. a refrigerant D. a water glyc...

unusual - ANSWER-If the seal was not properly aligned or there is excessive wear in some bearing or shaft,_______ wear tracks will be the indicator sharpened brass putty knife - ANSWER-For removing hard to remove gasket materials found on sealing surfaces, ______ is recommended Conducted on the job - ANSWER-Apprenticeship training is_______ distance - ANSWER-Charting alignment on a graph requires a chart that is divided into thousandths of an inch vertically for the indicator readings a...

BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES EXAM VERIFIED LATEST GUIDE ()BASIC GAS TURBINES E...

K-State AVM Turbines Exam 2 Latest Update...