A -bar - - (CORRECT REPLY) --Armature bar 1.5 is
standard length
When a bar is flat on front coil we are coil has between .010-.012 - -
(CORRECT REPLY) --Smaller creates more power it is
noticeable (more coil is more power)
Push the a bar down on the front coil hold machine up to the light
and check - - (CORRECT REPLY) --For dust lint etc. this
can cause your machine to rattle and deflect believe it or not just
blow debris with air can or mouth
Do not allow front spring to - - (CORRECT REPLY) --
Hangover the rear of the amateur Bar this can create a buzz and
undue vibration
A longer a bar extending past rear is fine - - (CORRECT
REPLY) --Creates a longer stroke and usually a longer a bar and
is 1.625 long
, Angle of contact screws does not matter much - - (CORRECT
REPLY) --As long as it turns on it's doing it's job however when
the spring strikes the contact on the up stroke the angle of the
contact screw can have an effect of the overall vibration of your
machine.
Once your machine is set up correctly it should - - (CORRECT
REPLY) --The angle should remain the same because the
Contacts crew should head at the very end or front of the spring
choose a front spring that is correct for your application
A short spring - - (CORRECT REPLY) --Will be faster. That
same spring but the higher angle will be faster yet a lower angle
makes it slower and softer hit
All metals are measured on the - - (CORRECT REPLY) --
Rockwell scale and find it best to be 48-51
Remember no matter the spring length the screw should - -
(CORRECT REPLY) --Hit the end of the spring