Michigan State Brakes
Certification Exam Newest 2026
Complete Questions | With 100%
Correct Answers graded A+
Guaranteed Success!!
1. A cracked or torn vacuum diaphragm in a brake
power booster would most likely cause:
Correct Answer: A hard pedal feel requiring very high
pedal effort to stop.
2. To test a vacuum power brake booster in the vehicle,
you should pump the brake pedal at least four times,
hold the brake pedal depressed, and start the engine.
The brake pedal should:
Correct Answer: Drop slightly and remain firm.
3. A mechanic finds gear lube inside both rear drums on
a rear-wheel-drive vehicle. What is most likely the
, cause of this problem?
Correct Answer: A plugged axle.
4. The rear brakes are dragging after having new
linings installed and the drums machined. The most
likely cause is the:
Correct Answer: Technician used the parking brake to
adjust the shoes and the cable is stuck.
5. While test-driving a car, the mechanic finds that the
right-front brake "grabs." The most likely cause of
this problem is:
Correct Answer: Brake fluid or grease on the brake
linings.
6. Which of the following incorrect service procedures
will cause brake lock-up?
Correct Answer: Master-cylinder pushrod adjusted too
long.
7. Which of the following incorrect service procedures
could cause brake-pedal pulsation?
Correct Answer: Incorrect run-out on the car brake
lathe.
8. A common cause of pedal pulsation during brake
application is:
Certification Exam Newest 2026
Complete Questions | With 100%
Correct Answers graded A+
Guaranteed Success!!
1. A cracked or torn vacuum diaphragm in a brake
power booster would most likely cause:
Correct Answer: A hard pedal feel requiring very high
pedal effort to stop.
2. To test a vacuum power brake booster in the vehicle,
you should pump the brake pedal at least four times,
hold the brake pedal depressed, and start the engine.
The brake pedal should:
Correct Answer: Drop slightly and remain firm.
3. A mechanic finds gear lube inside both rear drums on
a rear-wheel-drive vehicle. What is most likely the
, cause of this problem?
Correct Answer: A plugged axle.
4. The rear brakes are dragging after having new
linings installed and the drums machined. The most
likely cause is the:
Correct Answer: Technician used the parking brake to
adjust the shoes and the cable is stuck.
5. While test-driving a car, the mechanic finds that the
right-front brake "grabs." The most likely cause of
this problem is:
Correct Answer: Brake fluid or grease on the brake
linings.
6. Which of the following incorrect service procedures
will cause brake lock-up?
Correct Answer: Master-cylinder pushrod adjusted too
long.
7. Which of the following incorrect service procedures
could cause brake-pedal pulsation?
Correct Answer: Incorrect run-out on the car brake
lathe.
8. A common cause of pedal pulsation during brake
application is:
