pipefitter exam study guide 1 questions with correct answers.

pipefitter exam study guide 1 questions
with correct answers

what ||is ||the ||take ||out ||of ||a ||10" ||short ||radius ||weld ||90 ||elbow ||- ||CORRECT ||ANSWER✔✔-10"



acetylene ||bottles ||have ||fusible ||link ||that ||melts ||at ||what ||temp ||- ||CORRECT ||ANSWER✔✔-220
||degrees ||or ||212 ||best ||answer




what ||is ||the ||pressure ||inside ||of ||oxygen ||cylinder ||- ||CORRECT ||ANSWER✔✔-2000lbs/2500lbs



where ||the ||tags ||for ||ox ||bottles ||are ||located ||- ||CORRECT ||ANSWER✔✔-the ||shoulder ||of ||the ||
bottle



which ||direction ||does ||a ||hacksaw ||blade ||cut ||- ||CORRECT ||ANSWER✔✔-forward



what ||tubing ||bend ||is ||used ||in ||installation ||of ||pipe ||- ||CORRECT ||ANSWER✔✔-hickey



when ||handling ||a ||newly ||threaded ||piece ||of ||pipe ||you ||must ||be ||careful ||because ||its ||- ||
CORRECT ||ANSWER✔✔-sharp



what ||is ||the ||purpose ||of ||the ||foot ||pedal ||on ||a ||pipe ||threading ||machine ||- ||CORRECT ||
ANSWER✔✔-safety



when ||welding ||socket ||weld ||fittings ||what ||is ||the ||process ||- ||CORRECT ||ANSWER✔✔-shoulder ||
all ||the ||way ||then ||remove ||1/16 ||from ||shoulder ||and ||tack ||weld

, which ||code ||governs ||the ||installation ||of ||process ||piping ||- ||CORRECT ||ANSWER✔✔-B31.3



which ||valve ||is ||not ||appropriate ||as ||a ||boiler ||steam ||outlet ||valve ||on ||high ||pressure ||boilers ||-
||CORRECT ||ANSWER✔✔-ball ||valve




who ||is ||responsible ||to ||qualify ||a ||welder ||- ||CORRECT ||ANSWER✔✔-employer



what ||temperature ||does ||an ||oxy ||cutting ||torch ||run ||at ||- ||CORRECT ||ANSWER✔✔-5438 ||or ||
6630



which ||stamp ||is ||required ||for ||the ||assembly ||of ||high ||pressure ||boilers ||- ||CORRECT ||
ANSWER✔✔-"A" ||stamp



high ||pressure ||pipe ||welding ||and ||welder ||must ||be ||qualified ||to ||section ||______ ||of ||the ||
ASME ||code ||- ||CORRECT ||ANSWER✔✔-9



what ||welding ||position ||is ||commonly ||used ||for ||welding ||test ||that ||will ||qualify ||you ||for ||all ||
positions ||- ||CORRECT ||ANSWER✔✔-6G



what ||is ||the ||hardest ||welding ||position ||to ||use ||- ||CORRECT ||ANSWER✔✔-6



a ||stop ||valve ||and ||check ||valve ||are ||installed ||in ||the ||- ||CORRECT ||ANSWER✔✔-feed ||water ||
line



when ||piping ||up ||a ||low ||water ||cut ||off ||device ||to ||a ||boiler, ||the ||device ||must ||be ||piped ||to ||
what ||height ||in ||relation ||to ||the ||level ||of ||the ||gauge ||glass ||- ||CORRECT ||ANSWER✔✔-no ||lower
||than ||the ||visible ||part ||of ||the ||gauge ||glass