PIPEFITTER STAR EXAM ALL 500 QUESTIONS
AND CORRECT DETAILED ANSWERS LATEST
UPDATE THIS YEAR - JUST RELEASED
Save
Terms in this set (800)
What causes 90% of all Focus Hazards
construction injuries and
deaths and are used to
help OSHA inspectors
improve their
effectiveness?
What is the minimum safe 10 feet
working distance for
overhead power lines?
What is the standard Lockout/Tagout
procedure used to safely
de-energize equipment
on circuits before they are
worked on?
Which of the following is They can be written in any language
not true about Material
Safety Data Sheets?
What are the four focus Fall Hazards, Electrical Hazards, Caught in, Struck by
inspections OSHA
compliance officers look
for?
, The sizes of pipe are Nominal pipe size NPS
identified by the
measurement called the:
Steel pipe is supplied with PESC, T & C TBE
the following end finish (All of the above)
(es):
What is a typical type of Butt-welded, Socket-welded, Slip-on Flanged (All of
welded pipe joints? the above)
List the four principle Start/Stop, Regulate/Throttle, Relief, Reduce
functions of valves.
Regulating or throttling Both B and C, (globe and gate valve)
flow is done with a:
Name the two basic types Lift and Swing
of check valves.
The most common hanger Clevis
used in piping systems is
the:
Never expose any part of 125°F
a compressed gas
cylinder to temperatures
above:
The four types of copper compression
tube joints are soldered,
brazed, flared and _____?
What is the maximum 350 degrees F
recommended service
temperature when a
brazed joint is used?
Poor alignment of tube spacing difference between tubes and fittings
joints will cause:
AND CORRECT DETAILED ANSWERS LATEST
UPDATE THIS YEAR - JUST RELEASED
Save
Terms in this set (800)
What causes 90% of all Focus Hazards
construction injuries and
deaths and are used to
help OSHA inspectors
improve their
effectiveness?
What is the minimum safe 10 feet
working distance for
overhead power lines?
What is the standard Lockout/Tagout
procedure used to safely
de-energize equipment
on circuits before they are
worked on?
Which of the following is They can be written in any language
not true about Material
Safety Data Sheets?
What are the four focus Fall Hazards, Electrical Hazards, Caught in, Struck by
inspections OSHA
compliance officers look
for?
, The sizes of pipe are Nominal pipe size NPS
identified by the
measurement called the:
Steel pipe is supplied with PESC, T & C TBE
the following end finish (All of the above)
(es):
What is a typical type of Butt-welded, Socket-welded, Slip-on Flanged (All of
welded pipe joints? the above)
List the four principle Start/Stop, Regulate/Throttle, Relief, Reduce
functions of valves.
Regulating or throttling Both B and C, (globe and gate valve)
flow is done with a:
Name the two basic types Lift and Swing
of check valves.
The most common hanger Clevis
used in piping systems is
the:
Never expose any part of 125°F
a compressed gas
cylinder to temperatures
above:
The four types of copper compression
tube joints are soldered,
brazed, flared and _____?
What is the maximum 350 degrees F
recommended service
temperature when a
brazed joint is used?
Poor alignment of tube spacing difference between tubes and fittings
joints will cause:
