• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 3 out of 22 pages
Exam (elaborations)

Cal. Fire Weekly Fire Pump Certification: Sample Test & Answer Key

Document preview thumbnail
Preview 3 out of 22 pages

A practice test for firefighters preparing for the California Fire Apparatus Fire Pump Certification, often referred to as the "Cal. Fire Weekly" test. This sample includes questions on pump operation, hydraulic calculations, engine pressure, drafting, and apparatus safety based on standard practices and IFSTA/CPC guidelines.

Content preview

Cal. Fire Weekly Fire Pump Certification




Section 1: Fire Pump Components (10 Questions)
1. What is the primary function of a fire pump relief valve?

A) To maintain minimum pressure in the system B) To prevent overpressurization of the system
C) To increase flow rate during demand D) To bypass the pump during testing

Answer: B) To prevent overpressurization of the system Rationale: NFPA 20 (9.2.3) requires
relief valves to protect the system from excessive pressure.




2. Which component is responsible for preventing water from flowing back into
the pump after shutdown?

A) Pressure gauge B) Check valve C) Flow meter D) Suction strainer

Answer: B) Check valve Rationale: Check valves are installed to prevent backflow and maintain
system pressure.




3. The packing gland in a fire pump is used to:

A) Increase pump efficiency B) Prevent air from entering the pump C) Seal the shaft to prevent
water leakage D) Regulate pump speed

Answer: C) Seal the shaft to prevent water leakage Rationale: Packing glands prevent water
from leaking along the pump shaft.




4. What is the purpose of the suction strainer in a fire pump?

,A) To increase water velocity B) To prevent debris from entering the pump C) To measure
suction pressure D) To regulate pump flow

Answer: B) To prevent debris from entering the pump Rationale: Suction strainers protect the
pump from damage caused by debris.




5. Which of the following is NOT a component of a centrifugal fire pump?

A) Impeller B) Volute C) Piston D) Casing

Answer: C) Piston Rationale: Centrifugal pumps use impellers, not pistons.




6. The casing relief valve is designed to:

A) Increase pump efficiency B) Protect the pump from thermal damage C) Prevent cavitation D)
Regulate discharge pressure

Answer: C) Prevent cavitation Rationale: Casing relief valves prevent damage from cavitation
by maintaining minimum flow.




7. What does the pressure maintenance (jockey) pump do?

A) Provides primary fire protection flow B) Maintains system pressure during minor leaks C)
Replaces the main fire pump during testing D) Increases pump speed during demand

Answer: B) Maintains system pressure during minor leaks Rationale: Jockey pumps maintain
pressure and prevent unnecessary main pump starts.




8. The controller for an electric motor-driven fire pump must be:

A) Manually operated B) Listed for fire pump service C) Connected to the building’s main power
D) Located in a separate building

Answer: B) Listed for fire pump service Rationale: NFPA 20 (10.5.1) requires controllers to be
listed for fire pump duty.

, 9. What is the purpose of the flow meter in a fire pump system?

A) To measure pump efficiency B) To indicate the rate of water flow C) To regulate pump speed
D) To prevent cavitation

Answer: B) To indicate the rate of water flow Rationale: Flow meters provide real-time flow data
during testing and operation.




10. The suction pipe for a fire pump must be sized to:

A) Match the discharge pipe diameter B) Prevent cavitation and ensure adequate flow C)
Increase pump speed D) Reduce system pressure

Answer: B) Prevent cavitation and ensure adequate flow Rationale: NFPA 20 (4.15) specifies
suction pipe sizing to prevent cavitation.




Section 2: Diesel Engine Fire Pumps (10 Questions)
11. What is the minimum fuel supply required for a diesel fire pump?

A) 1 gallon per horsepower B) 1 gallon per hour of operation C) Enough for 8 hours of full-load
operation D) Enough for 24 hours of standby

Answer: C) Enough for 8 hours of full-load operation Rationale: NFPA 20 (11.2.3) requires fuel
for 8 hours at full load.




12. Diesel fire pumps must be tested weekly for:

A) Fuel consumption B) Battery voltage C) Automatic start and run D) Oil pressure

Answer: C) Automatic start and run Rationale: NFPA 25 (8.3.1) requires weekly automatic start
tests.




13. What is the purpose of the battery charger on a diesel fire pump?

A) To start the engine B) To maintain battery charge during standby C) To increase engine RPM
D) To regulate fuel flow

Document information

Uploaded on
November 26, 2025
Number of pages
22
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
$9.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
STUDYACEFILES
3.9
(19)
Sold
125
Followers
6
Items
2605
Last sold
3 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions