TCFP Aerial Operator Exam Questions and
Answers 100% Pass
Which test is performed to ensure that the pumps and associated piping
are capable of withstanding high pressure pumping demands? -
Answer: Hydrostatic testing
Question: Foam proportioning equipment testing should occur before
being placed in service and: -
Answer: periodically thereafter.
Question: Pump testing should be performed: -
Answer: during both acceptance tests and certification tests.
,Question: Which foam proportioner test measures the velocity of light
that travels through foam and compares it to a base reading? -
Answer: Foam solution refractivity test
Question: A flowmeter might be used instead of a pitot gauge during a
pump performance test, because flowmeters are: -
Answer: more efficient.
Question: What is the purpose of acceptance testing? -
Answer: To demonstrate to the purchaser that the apparatus conforms
to all bid specifications at the time of delivery
Question: If a jurisdiction seeks special requirements from the
manufacturer to ensure that the apparatus will perform as required
under local conditions, they may be written into the bid specifications as:
-
Answer: performance requirements.
, Question: What is the maximum speed that must be reached by
apparatus during road tests? -
Answer: 50 mph (80 km/h)
Question: According to NFPA® 1911, all gauges used for service
testing must be calibrated within _____ of testing. -
Answer: 60 days
Question: Which apparatus performance tests require that a discharge
hoseline from a second pumper be connected to the apparatus being
tested? -
Answer: Internal intake pressure relief valve test
Question: When securing a detachable ladder pipe system on an aerial
ladder, the hose should be run directly up the center of the ladder rungs
because: -
Answers 100% Pass
Which test is performed to ensure that the pumps and associated piping
are capable of withstanding high pressure pumping demands? -
Answer: Hydrostatic testing
Question: Foam proportioning equipment testing should occur before
being placed in service and: -
Answer: periodically thereafter.
Question: Pump testing should be performed: -
Answer: during both acceptance tests and certification tests.
,Question: Which foam proportioner test measures the velocity of light
that travels through foam and compares it to a base reading? -
Answer: Foam solution refractivity test
Question: A flowmeter might be used instead of a pitot gauge during a
pump performance test, because flowmeters are: -
Answer: more efficient.
Question: What is the purpose of acceptance testing? -
Answer: To demonstrate to the purchaser that the apparatus conforms
to all bid specifications at the time of delivery
Question: If a jurisdiction seeks special requirements from the
manufacturer to ensure that the apparatus will perform as required
under local conditions, they may be written into the bid specifications as:
-
Answer: performance requirements.
, Question: What is the maximum speed that must be reached by
apparatus during road tests? -
Answer: 50 mph (80 km/h)
Question: According to NFPA® 1911, all gauges used for service
testing must be calibrated within _____ of testing. -
Answer: 60 days
Question: Which apparatus performance tests require that a discharge
hoseline from a second pumper be connected to the apparatus being
tested? -
Answer: Internal intake pressure relief valve test
Question: When securing a detachable ladder pipe system on an aerial
ladder, the hose should be run directly up the center of the ladder rungs
because: -
