1
Texas State Inspector Safety cert.
Questions and Correct Answers
One of the required procedures in the inspection of the
steering is: Answer: Turning the steering wheel from
full left to full right
Conventional brakes or non-power brakes must have a
minimum pedal reserve of: Answer: 2 inch
Any tire with wear bar indicators would be rejected for
the following reason: Answer: Tread wear indicators
contact the road on any two adjacent major grooves in
the center of the middle of the tire
LED tail lamps may have no more than ______ of
diodes malfunctioning to pass inspection. Answer:
50%
When performing a road test on the service brakes, a
truck weighing over 10,000 lbs GVW (this would
include larger trucks but not truck-trailer combinations)
should be driven at a speed of 20 mph and should stop
within: Answer: 40 feet
Pretest - Stuvia US
, 2
The vehicle owner/operator should be present when
the inspector is checking CNG tank located in the trunk
of the car. Answer: True
Glass coating or sun screening materials on windshield
may not extend down past the AS-1 line or more than
____ inches, whichever is closer to the top of the
windshield: Answer: 5 inches
Brakes would be rejected if: Answer: There is obvious
metal to metal contact when brakes are applied.
When issuing a Vehicle Inspection Report to a vehicle,
the VIN will be taken from the: Answer: Vehicle
Proof of financial responsibility is not required on motor
vehicles prior to the model year 1988. Answer: False
When is a vehicle required to be inspected for seat
belts? Answer: Anchorages were part of the
manufactures original equipment
The turn signal selector switch must lock in the proper
position when applied on: Answer: All vehicles
Pretest - Stuvia US
Texas State Inspector Safety cert.
Questions and Correct Answers
One of the required procedures in the inspection of the
steering is: Answer: Turning the steering wheel from
full left to full right
Conventional brakes or non-power brakes must have a
minimum pedal reserve of: Answer: 2 inch
Any tire with wear bar indicators would be rejected for
the following reason: Answer: Tread wear indicators
contact the road on any two adjacent major grooves in
the center of the middle of the tire
LED tail lamps may have no more than ______ of
diodes malfunctioning to pass inspection. Answer:
50%
When performing a road test on the service brakes, a
truck weighing over 10,000 lbs GVW (this would
include larger trucks but not truck-trailer combinations)
should be driven at a speed of 20 mph and should stop
within: Answer: 40 feet
Pretest - Stuvia US
, 2
The vehicle owner/operator should be present when
the inspector is checking CNG tank located in the trunk
of the car. Answer: True
Glass coating or sun screening materials on windshield
may not extend down past the AS-1 line or more than
____ inches, whichever is closer to the top of the
windshield: Answer: 5 inches
Brakes would be rejected if: Answer: There is obvious
metal to metal contact when brakes are applied.
When issuing a Vehicle Inspection Report to a vehicle,
the VIN will be taken from the: Answer: Vehicle
Proof of financial responsibility is not required on motor
vehicles prior to the model year 1988. Answer: False
When is a vehicle required to be inspected for seat
belts? Answer: Anchorages were part of the
manufactures original equipment
The turn signal selector switch must lock in the proper
position when applied on: Answer: All vehicles
Pretest - Stuvia US
