Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 2 out of 9 pages
Exam (elaborations)

ASE - Auto Maintenance and Light Repair Study Guide Questions and An- swers

Document preview thumbnail
Preview 2 out of 9 pages

ASE - Auto Maintenance and Light Repair Study Guide Questions and An- swers

Content preview

ASE - Auto Maintenance and Light Repair Study Guide Questions and An
swers
Study online at https://quizlet.com/_i3iham
1. Technician A says that when pressure testing a radiator cap, a special adapter
is needed. Technician B says the best way to check thermostat operation is
while it is in the engine. Who is right?: Tech A
2. A technician is checking resistance in an engine's spark plug wires using an
ohmmeter. A general rule is to replace a wire if resistance is over:: 30,000 ohms
3. Technician A says that in an ignition system, the voltage supplied to the coil
during starting is battery voltage. Technician B says the coil uses electromag-
netic induction to create high voltage. Who is right?: Both techs
4. A front wheel drive vehicle with an automatic transaxle has excessive vi-
bration. Technician A says that the vibration could be caused by worn en-
gine/transaxle mounts. Technician B says that the vibration could be caused
by a misaligned engine/transaxle subframe. Who is right?: Both techs
5. A technician suspects that a faulty camshaft sensor causes a driveability
complaint. The sensor is equipped with a three-wire connector. What type of
sensor is this?: a Hall effect type
6. All of the following can cause a problem in the Hydro-boost system EXCEPT:
A. loose power steering pump belt
B. leaking power steering hoses
C. low power steering pump pressure
D. leaking check valve: D
7. Technician A says that if a wire is getting too hot, it's a sign of higher-than-nor-
mal current flowing through. Technician B says the wire would heat up if some
of the individual strands are broken inside the wire insulation. Who is right?: Both
techs
8. Technician A says electrical connectors can be disconnected with the ignition
switch ON, as long as the technician is using a ground strap. Technician B says
when welding on a vehicle, the technician needs to use a static wrist strap. Who
is right?: Neither
9. Technician A says the thermostat maintains maximum engine operating tem-
perature. Technician B says if the engine continuously runs hot, install a cooler
thermostat. Who is right?: Neither
1/9

, ASE - Auto Maintenance and Light Repair Study Guide Questions and An
swers
Study online at https://quizlet.com/_i3iham
10. A vehicle equipped with a MacPherson strut suspension is in the repair shop
for new tires and an alignment. The technician noticed that the vehicle has
some play in the lift-side inner tie-rod. What should the technician tell the
customer?
A. It is not a problem that will affect alignment.
B. He can align the front end, but the tie-rod should be replaced soon
C. The inner tie-rod needs to be replaced before an alignment can be per-
formed
D. He can set the vehicle alignment to compensate for the play in the inner
tie-rod: C.
11. An engine is losing coolant, yet has no external leaks. Technician A says to
run the engine and see if there is white smoke out of the exhaust. Technician
B says to find out if the engine's emission system uses a catalytic converter
before running the test above. Who is right?: both
12. LED bulbs can remain effective for up to how long depending on the size of
the bulb and the conditions to which the bulb is exposed?: 15000 hours
13. All of the following should be performed during a preliminary transmission
inspection EXCEPT:
A. check transmission fluid level
B. visually check wiring and electrical connections
C. check the condition of the filter
D. check for fluid leaks: C
14. A smeary film on the windshield is an indication of:
A. evaporator core leak
B. water valve leak
C. heater core leak
D. restricted drain hose: C
15. Technician A says that all power should be removed from a circuit before
testing the circuit with an ammeter. Technician B says that all power should
be removed from a circuit before testing the circuit with an ohmmeter. Who is
right?: Tech B
2/9

Document information

Uploaded on
October 18, 2025
Number of pages
9
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
$12.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
BrittieDonald
3.4
(101)
Sold
460
Followers
162
Items
22019
Last sold
2 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions