TOTAL FORCE MWS QUESTIONS
WITH ACCURATE ANSWERS
"C" in the formula FL=C Q^2 L represents the: correct answer Hose diameter
coefficient.
A priming device works by: correct answer Creating a partial vacuum.
According to NFPA 1901, a discharge pressure relief valve must operate within:
correct answer 10 seconds after discharge pressure rises 30 psi above the set
level.
All of the following are important reasons for maintaining inspection documents
on a MWS apparatus EXCEPT: correct answer Verifying that you are inspection the
correct apparatus.
All of the following are types of portable water tanks EXCEPT: correct answer
Locking tanks.
All of the following factors must be included when determining the total pressure
loss (TPL) EXCEPT: correct answer Pump pressure loss.
All of the following statements about driving an MWS apparatus through areas of
restricted horizontal and vertical clearances are true EXCEPT: correct answer Use
the appropriate turn signal.
, All of the following statements about static water sources are true EXCEPT:
correct answer The static water source that is closest to the incident should
always be used first.
Allowing and MWS apparatus engine to idle over an extended period of time can
lead to all of the following EXCEPT: correct answer Engine fatigue.
As operations proceed during water shuttles, make and break personnel at the fill
site should monitor: correct answer Ground conditions.
At a fill site, a cone or similar device is used to: correct answer Mark the stopping
point for an MWS apparatus.
At a water shuttle operation, the amount of water dumped is the amount of
weather the tank hold less: correct answer 10%.
At a water shuttle operation, the second and subsequent mobile water supply
apparatuses may leave the dump site once: correct answer Their entire load has
been dumped.
Before driving over a guarded railroad crossing during an emergency response:
correct answer Look both right and left and proceed cautiously.
During an MWS apparatus inspection, the lowest acceptable fuel gauge reading is:
correct answer At least 3/4 - full.
WITH ACCURATE ANSWERS
"C" in the formula FL=C Q^2 L represents the: correct answer Hose diameter
coefficient.
A priming device works by: correct answer Creating a partial vacuum.
According to NFPA 1901, a discharge pressure relief valve must operate within:
correct answer 10 seconds after discharge pressure rises 30 psi above the set
level.
All of the following are important reasons for maintaining inspection documents
on a MWS apparatus EXCEPT: correct answer Verifying that you are inspection the
correct apparatus.
All of the following are types of portable water tanks EXCEPT: correct answer
Locking tanks.
All of the following factors must be included when determining the total pressure
loss (TPL) EXCEPT: correct answer Pump pressure loss.
All of the following statements about driving an MWS apparatus through areas of
restricted horizontal and vertical clearances are true EXCEPT: correct answer Use
the appropriate turn signal.
, All of the following statements about static water sources are true EXCEPT:
correct answer The static water source that is closest to the incident should
always be used first.
Allowing and MWS apparatus engine to idle over an extended period of time can
lead to all of the following EXCEPT: correct answer Engine fatigue.
As operations proceed during water shuttles, make and break personnel at the fill
site should monitor: correct answer Ground conditions.
At a fill site, a cone or similar device is used to: correct answer Mark the stopping
point for an MWS apparatus.
At a water shuttle operation, the amount of water dumped is the amount of
weather the tank hold less: correct answer 10%.
At a water shuttle operation, the second and subsequent mobile water supply
apparatuses may leave the dump site once: correct answer Their entire load has
been dumped.
Before driving over a guarded railroad crossing during an emergency response:
correct answer Look both right and left and proceed cautiously.
During an MWS apparatus inspection, the lowest acceptable fuel gauge reading is:
correct answer At least 3/4 - full.
