PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
How is a diamond condition fixed?
By pulling the damage for length. Diamond is a length condition.
When measuring a unibody vehicle, it is discovered that the left front rail is 111mm from spec in
width. What condition is this?
Width is calculated from the center out, so a value of -111mm on the left rail shows sway to the
right and in toward centerline.
A collision damaged vehicle is discovered to be down in height at opposite end of the center
section.
Twist condition.
When diagnosing the damage to a full frame assembly on a sport utility vehicle, it is determined
that the left side frame rail is higher than the right side frame rail. Technician A says the damaged
state is known as a twist condition. Technician B says a sway condition exists. Who is right?
Tech A. When a frame rail's relationship to the vehicle centerline is changed, such as pushed
either to the left or right, the condition is known as sway. "Twist" is referred as the condition of
the frame when entire sections are driven higher or lower than the opposite side.
Metal fillers contain different ingredients that provide fillers with special properties.
Fiberglass offers more resistance to moisture
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
HSLA
High Strength Low Alloy
When replacing the floor pan in the trunk area, what joint should be used to join the new pan to
the existing floor?
An overlap joint
When acoustical foam is removed during the repair:
It must be replaced with acoustical foam.
When setting up a three-dimensional measuring system, it should be setup on an undamaged
area.
Starting in the center section is the correct method.
What is the plastic Black box in rear of the car?
Vapor Canister
Grinding or squeaking from wheel is a sign of what?
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
Bad Bearings
The insurance commissioner is responsible for everything except?
Endorsing an insurance company
How do you tell when a ball joint is bad?
Measure fixed points from knuckle to rotor
What makes the windows go up and down?
Window regulator
What panel needs to get removed is there is damage to the quarter panel?
The taillight
Actuator
Tells something to do something
Sensor
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
Take reading and tell when something is wrong
What is Urethane Paint?
Better than acrylic, extremely durable, and resists chipping; easier to apply
What makes up the body of the vehicle?
Anything that is welded together
Who has the first right to salvage?
The insurer
What components make up a unibody?
Last answer, longest answer on exam question
What needs to be on an appraisal?
A license number
The photo of the Buick sedan with a rear fixed axle:
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
How is a diamond condition fixed?
By pulling the damage for length. Diamond is a length condition.
When measuring a unibody vehicle, it is discovered that the left front rail is 111mm from spec in
width. What condition is this?
Width is calculated from the center out, so a value of -111mm on the left rail shows sway to the
right and in toward centerline.
A collision damaged vehicle is discovered to be down in height at opposite end of the center
section.
Twist condition.
When diagnosing the damage to a full frame assembly on a sport utility vehicle, it is determined
that the left side frame rail is higher than the right side frame rail. Technician A says the damaged
state is known as a twist condition. Technician B says a sway condition exists. Who is right?
Tech A. When a frame rail's relationship to the vehicle centerline is changed, such as pushed
either to the left or right, the condition is known as sway. "Twist" is referred as the condition of
the frame when entire sections are driven higher or lower than the opposite side.
Metal fillers contain different ingredients that provide fillers with special properties.
Fiberglass offers more resistance to moisture
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
HSLA
High Strength Low Alloy
When replacing the floor pan in the trunk area, what joint should be used to join the new pan to
the existing floor?
An overlap joint
When acoustical foam is removed during the repair:
It must be replaced with acoustical foam.
When setting up a three-dimensional measuring system, it should be setup on an undamaged
area.
Starting in the center section is the correct method.
What is the plastic Black box in rear of the car?
Vapor Canister
Grinding or squeaking from wheel is a sign of what?
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
Bad Bearings
The insurance commissioner is responsible for everything except?
Endorsing an insurance company
How do you tell when a ball joint is bad?
Measure fixed points from knuckle to rotor
What makes the windows go up and down?
Window regulator
What panel needs to get removed is there is damage to the quarter panel?
The taillight
Actuator
Tells something to do something
Sensor
, PA Appraisers License Updated Exam |
Questions and Answers| Latest 2026/ 2027
Update |100 out of 100 (Grade A)
Take reading and tell when something is wrong
What is Urethane Paint?
Better than acrylic, extremely durable, and resists chipping; easier to apply
What makes up the body of the vehicle?
Anything that is welded together
Who has the first right to salvage?
The insurer
What components make up a unibody?
Last answer, longest answer on exam question
What needs to be on an appraisal?
A license number
The photo of the Buick sedan with a rear fixed axle:
