Motor Vehicle Unit 151 Exam Questions And Answers With
100% Verified Solutions!!!
1. A deep scratch caused by the
Recorded on the work order.
technician`s overalls when servicing a
vehicle should be:
2. What sensor is fitted to a diesel fuel filter? Water
3. Excessive front wheel negative tyre wear on the outer edges.
toe(toe in) would cause:
4. A worn steering part found during Customer
service in- spection should only be
replaced when per- mission has been
sought from the:
5. Valve clearances are measured with a: feeler blade
6. A water filter is always found on: Diesel 4 stroke engines
7. What would a technician do to check Conduct a brake roller test.
the effi- ciency of a vehicles front
brakes?
Warped brake discs.
8. Under normal braking conditions the
brake pedal pulses up and down; the
likely cause of this is:
middle of the tread
9. Over inflated tyre pressures cause
premature tyre wear to:
10. Two types of spark plug sealing devices are; washer and taper set
11. A tyre which has a tread depth of 1.5mm is unserviceable as it is just below
the
legal limit.
1/
3
100% Verified Solutions!!!
1. A deep scratch caused by the
Recorded on the work order.
technician`s overalls when servicing a
vehicle should be:
2. What sensor is fitted to a diesel fuel filter? Water
3. Excessive front wheel negative tyre wear on the outer edges.
toe(toe in) would cause:
4. A worn steering part found during Customer
service in- spection should only be
replaced when per- mission has been
sought from the:
5. Valve clearances are measured with a: feeler blade
6. A water filter is always found on: Diesel 4 stroke engines
7. What would a technician do to check Conduct a brake roller test.
the effi- ciency of a vehicles front
brakes?
Warped brake discs.
8. Under normal braking conditions the
brake pedal pulses up and down; the
likely cause of this is:
middle of the tread
9. Over inflated tyre pressures cause
premature tyre wear to:
10. Two types of spark plug sealing devices are; washer and taper set
11. A tyre which has a tread depth of 1.5mm is unserviceable as it is just below
the
legal limit.
1/
3
