USPA Category D QUIZ ACTUAL Questions and Verified Solutions Latest Update This Year

Page 1 of 76



USPA Category D QUIZ ACTUAL Questions and
Verified Solutions Latest Update This Year
USPA Category D

QUESTION: What is the best way to avoid a canopy collision when turning? - ANSWER-Look first
in the direction of the turn.




QUESTION: What is the quickest and safest way to change heading immediately after opening?
- ANSWER-rear riser turn with the brakes still set




QUESTION: How would you steer a parachute that has a broken brake line? - ANSWER-use the
rear risers




QUESTION: How would you prepare to land a canopy using the rear risers to flare? - ANSWER-
practice with rear-riser flares at altitude with that canopy during a routine jump




QUESTION: Describe your procedure for landing on a building - ANSWER-Disconnect the RSL (if
time), contact the building feet first, PLF, cut away after landing on top of a building, wait for
competent help.




QUESTION: What is the purpose of the automatic activation device? - ANSWER-to back up the
jumper's emergency procedures

, Page 2 of 76




Q; For planned deployment initiation at 3,000 feet, approximately how long should an average-
sized jumper fall after exiting at 5,000 feet? - ANSWER-15 seconds




QUESTION: What is the most appropriate response to loss of heading control in freefall? -
ANSWER-altitude, arch, legs, relax




QUESTION: Describe the "check of threes." - ANSWER-Check three-ring release system for
correct assembly and RSL; three points of harness attachment for snap

assembly or correct routing and adjustment; three operation handles—main activation,
cutaway, reserve.




QUESTION: What must the spotter do to determine what is directly underneath the aircraft
while on jump run? - ANSWER-place head completely outside the aircraft and look straight
down




QUESTION: How far horizontally must jumpers be

from any cloud?




a. below 10,000 feet MSL?

, Page 3 of 76


b. 10,000 feet MSL and above? - ANSWER-a. below 10,000 feet MSL? 2,000 feet;




b. 10,000 feet MSL and above? one mile




QUESTION: What are the minimum visibility requirements?




a. below 10,000 feet MSL?




b. 10,000 feet MSL and above? - ANSWER-a. below 10,000 feet MSL? three miles




b. 10,000 feet MSL and above? five

miles




QUESTION: Who is responsible for a jumper observing cloud clearance

requirements? - ANSWER-jumper and pilot




QUESTION: According to the BSRs, what is the latest a student may jump? - ANSWER-All
student jumps must be completed by sunset.

, Page 4 of 76


QUESTION: Describe the technique for determining the point straight below the aircraft during
jump run. - ANSWER-Determine two lines from the horizon, one ahead and one abreast, and
find the intersection of those two lines.




QUESTION: What must the jumper look for below before exiting the aircraft? - ANSWER-clouds
and other aircraft




QUESTION:

USPA Category E

QUESTION: 1) What happens to a visual altimeter when it's in the jumper's burble?




a) Reads unreliably.

b) Nothing.

c) Reads high. - ANSWER-a) Reads unreliably.




QUESTION: 2) What is the best way to recover from a stall to full glide?




a) Quickly counteract with toggle input.

b) Pull legs up into a tight ball.

c) Smoothly raise the controls. - ANSWER-c) Smoothly raise the controls