MASTER PLUMBER MODULE -
PRACTICAL PROBLEM fully solved
already passed
FOUR - correct answer ✔✔The total number of closets on a 3-inch stack (vertical) is
___________
B0RED WELLS - correct answer ✔✔These are dug with earth augers and usually 30 meters (100
ft) deep. The diameter ranges from 2 to 30 inches. The well is lined with metal, vitrified tile or
concrete.
Five Years - correct answer ✔✔According to RA 1378 for at least how many years must the
appointee to the Board of Master Plumbers must have been activity in person engaged in the
trade of plumbing?
20 to 25 inches above the finished floor line - correct answer ✔✔When specifications are not
available, install urinal so the lip height is?
Pollution - correct answer ✔✔Organic matter or sewage contamination on water.
Polybutelene - correct answer ✔✔A flexible type of pipe known to have the only flexible plastic
tubing suitable for use with hot and color pressure system. And its also known as an excellent
chemical resistance to acids and alkali but is not suited for fuel oil, gasoline or kerosene
distribution system. (blue or gray pipe)
Left - correct answer ✔✔For hot and cold water distribution system, on what side should the
hot water supply be placed in combination fittings?
, Establishing a grade line then digging the trench exactky this line - correct answer ✔✔The
proper fall for a house sewer is established by?
An indirect waste pipe - correct answer ✔✔A refrigetrator used to store food and tha requires
drainage shall be drained by means of __________
Waste water runs away from solids, eventually causing stoppages - correct answer ✔✔What
may happen if a sewer pipe is laid with a fall greate than 1/4 inch per foot?
Solder - correct answer ✔✔What type of pipe joints
64 mm (2 1/2") - correct answer ✔✔The standard size of an outlet of a dry standpipe located
for each floor is _________ mm.
Hardness - correct answer ✔✔Water quality problem caused by the presence of Magnesium
and Calcium.
Submersible pump - correct answer ✔✔A pump used underground.
Solvent Welding - correct answer ✔✔Which of the following methods of jointing plastics used
for dishcharge pipework system is BEST described as a cold welding process?
Individual house pipe in connection with meter - correct answer ✔✔Where does the Level III
type of water service retrieved?
Plastic Pipe - correct answer ✔✔The building sewer is usually made of clay tile, cast iron,
asbestos-cement, or?
PRACTICAL PROBLEM fully solved
already passed
FOUR - correct answer ✔✔The total number of closets on a 3-inch stack (vertical) is
___________
B0RED WELLS - correct answer ✔✔These are dug with earth augers and usually 30 meters (100
ft) deep. The diameter ranges from 2 to 30 inches. The well is lined with metal, vitrified tile or
concrete.
Five Years - correct answer ✔✔According to RA 1378 for at least how many years must the
appointee to the Board of Master Plumbers must have been activity in person engaged in the
trade of plumbing?
20 to 25 inches above the finished floor line - correct answer ✔✔When specifications are not
available, install urinal so the lip height is?
Pollution - correct answer ✔✔Organic matter or sewage contamination on water.
Polybutelene - correct answer ✔✔A flexible type of pipe known to have the only flexible plastic
tubing suitable for use with hot and color pressure system. And its also known as an excellent
chemical resistance to acids and alkali but is not suited for fuel oil, gasoline or kerosene
distribution system. (blue or gray pipe)
Left - correct answer ✔✔For hot and cold water distribution system, on what side should the
hot water supply be placed in combination fittings?
, Establishing a grade line then digging the trench exactky this line - correct answer ✔✔The
proper fall for a house sewer is established by?
An indirect waste pipe - correct answer ✔✔A refrigetrator used to store food and tha requires
drainage shall be drained by means of __________
Waste water runs away from solids, eventually causing stoppages - correct answer ✔✔What
may happen if a sewer pipe is laid with a fall greate than 1/4 inch per foot?
Solder - correct answer ✔✔What type of pipe joints
64 mm (2 1/2") - correct answer ✔✔The standard size of an outlet of a dry standpipe located
for each floor is _________ mm.
Hardness - correct answer ✔✔Water quality problem caused by the presence of Magnesium
and Calcium.
Submersible pump - correct answer ✔✔A pump used underground.
Solvent Welding - correct answer ✔✔Which of the following methods of jointing plastics used
for dishcharge pipework system is BEST described as a cold welding process?
Individual house pipe in connection with meter - correct answer ✔✔Where does the Level III
type of water service retrieved?
Plastic Pipe - correct answer ✔✔The building sewer is usually made of clay tile, cast iron,
asbestos-cement, or?
