CHFM STUDY GUIDE LATEST
Which of the following are design standards typically dictated by the
facility for a renovation project?
1. Door hardware
2. Light ballast
3. Plumbing fixtures
4. Dry wall - ANSWERS-1, 3, and 4
Which of the following major factors should be considered in evaluating
life cycle costs?
1. Life expectancy
2. Operating costs
3. Purchase price
END OF
PAGE
1
, CHFM STUDY GUIDE LATEST
4. Equipment capacity - ANSWERS-1, 3, and 4
It is permitted to make a code announcement rather than using an
audible alarm while conducting a fire drill between what hours of
operation? - ANSWERS-10:00 PM to 7:00 AM
A facility manager is planning to install a new generator set for peak
shaving and carrying all facility loads. Which of the following switches
should be installed to maximize interruptions and facilitate
maintenance? - ANSWERS-Closed transition with bypass-isolation
Infrared testing of an electrical distribution system will detect: -
ANSWERS-Mislabeled panel ledgers with lighting loads
When reviewing a capital equipment request, the facility manager's
FIRST concerns are:
1. Cost
2. Electrical
END OF
PAGE
2
, CHFM STUDY GUIDE LATEST
3. Location
4. Mechanical - ANSWERS-1, 2, and 4
The efficiency of a steam boiler system is improved by: - ANSWERS-
Increasing steam operating pressure
Which of the following specifies the placement of smoke detectors in
corridors and at openings in fire and smoke separations? - ANSWERS-
NFPA 1 - Fire Prevention Code
What is the maximum distance that fire extinguishers may be spaced
from one another? - ANSWERS-100 feet
A patient unit contains 10,000 gross sq. ft. The unit is composed of 30
patient rooms of 200 net sq. ft. each and circulation/utility of 3,000 net
sq. ft. What is the percent net gross sq. ft. ratio? - ANSWERS-60
END OF
PAGE
3
Which of the following are design standards typically dictated by the
facility for a renovation project?
1. Door hardware
2. Light ballast
3. Plumbing fixtures
4. Dry wall - ANSWERS-1, 3, and 4
Which of the following major factors should be considered in evaluating
life cycle costs?
1. Life expectancy
2. Operating costs
3. Purchase price
END OF
PAGE
1
, CHFM STUDY GUIDE LATEST
4. Equipment capacity - ANSWERS-1, 3, and 4
It is permitted to make a code announcement rather than using an
audible alarm while conducting a fire drill between what hours of
operation? - ANSWERS-10:00 PM to 7:00 AM
A facility manager is planning to install a new generator set for peak
shaving and carrying all facility loads. Which of the following switches
should be installed to maximize interruptions and facilitate
maintenance? - ANSWERS-Closed transition with bypass-isolation
Infrared testing of an electrical distribution system will detect: -
ANSWERS-Mislabeled panel ledgers with lighting loads
When reviewing a capital equipment request, the facility manager's
FIRST concerns are:
1. Cost
2. Electrical
END OF
PAGE
2
, CHFM STUDY GUIDE LATEST
3. Location
4. Mechanical - ANSWERS-1, 2, and 4
The efficiency of a steam boiler system is improved by: - ANSWERS-
Increasing steam operating pressure
Which of the following specifies the placement of smoke detectors in
corridors and at openings in fire and smoke separations? - ANSWERS-
NFPA 1 - Fire Prevention Code
What is the maximum distance that fire extinguishers may be spaced
from one another? - ANSWERS-100 feet
A patient unit contains 10,000 gross sq. ft. The unit is composed of 30
patient rooms of 200 net sq. ft. each and circulation/utility of 3,000 net
sq. ft. What is the percent net gross sq. ft. ratio? - ANSWERS-60
END OF
PAGE
3
