SACA 201 Silver Exam with Questions and Verified Answers
Latest Update 2025
A(n) __________ is used to measure resistance.
Ohmmeter
What is the total measurement of voltage over the power source called?
Applied Voltage
Rotary motion is the output of which electrical output device?
Motor
Current is measured in units of __________.
Amps
What step should be taken to correctly measure the resistance of a resistor
that is wired in a circuit?
Disconnect one end of the resistor
The resistance provided by an inductor in an AC circuit is called
__________.
Inductive reactance
What does hertz stand for on a sine wave graph?
Cycles per second
What is the total inductance of a series circuit if the power supply
frequency is 60 Hz and 3 coils each have an inductance of 0.3 henrys?
0.9 Henrys
A common application of mutual inductance is found in a device called a
__________.
Transformer
, SACA 201 Silver Exam with Questions and Verified Answers
Latest Update 2025
What is the secondary voltage if the primary is 480VAC? (The primary coil
have 300 turns and the secondary coil has 125 turns)*
200 VAC
Which of the following is not a component of a basic electrical circuit?
Insulator
What is the thin insulator placed between the plates of a capacitor called?
Dielectric
One of the effects a capacitor has in a DC circuit is that it will
__________.
Charge to a voltage equal to the source voltage
Capacitance is measured in __________.
Farads
What is a drawing showing electrical symbols and paths?
Schematic
Current in a(n) __________ circuit is divided among the branches of the
circuit.
Parallel
When the wire or foil strip inside a fuse melts, the fuse is said to be
_________.
Blown
The potential difference between two points in a circuit is called
__________.
Voltage
Latest Update 2025
A(n) __________ is used to measure resistance.
Ohmmeter
What is the total measurement of voltage over the power source called?
Applied Voltage
Rotary motion is the output of which electrical output device?
Motor
Current is measured in units of __________.
Amps
What step should be taken to correctly measure the resistance of a resistor
that is wired in a circuit?
Disconnect one end of the resistor
The resistance provided by an inductor in an AC circuit is called
__________.
Inductive reactance
What does hertz stand for on a sine wave graph?
Cycles per second
What is the total inductance of a series circuit if the power supply
frequency is 60 Hz and 3 coils each have an inductance of 0.3 henrys?
0.9 Henrys
A common application of mutual inductance is found in a device called a
__________.
Transformer
, SACA 201 Silver Exam with Questions and Verified Answers
Latest Update 2025
What is the secondary voltage if the primary is 480VAC? (The primary coil
have 300 turns and the secondary coil has 125 turns)*
200 VAC
Which of the following is not a component of a basic electrical circuit?
Insulator
What is the thin insulator placed between the plates of a capacitor called?
Dielectric
One of the effects a capacitor has in a DC circuit is that it will
__________.
Charge to a voltage equal to the source voltage
Capacitance is measured in __________.
Farads
What is a drawing showing electrical symbols and paths?
Schematic
Current in a(n) __________ circuit is divided among the branches of the
circuit.
Parallel
When the wire or foil strip inside a fuse melts, the fuse is said to be
_________.
Blown
The potential difference between two points in a circuit is called
__________.
Voltage
