IMSA SIGNAL TECHNICIAN LEVEL 1
END OF CHAPTER QUESTIONS AND
ANSWERS 2025/2026
, What is the primary function of the IMSA? - ANSWERSSafety education
IMSA stands for: - ANSWERSInternational Municipal Signal Association
Which of the following is NOT an IMSA certification? - ANSWERSY: Traffic Signal Level
II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - ANSWERSOverhead and
underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - ANSWERSCircular red, circular green
PPE stands for: - ANSWERSPersonal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of
aerial lift equipment? - ANSWERSFull body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
ANSWERSEnsure advance warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - ANSWERSY:
Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason
not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic
Control Signals: - ANSWERSThree-section traffic signal with circular red, circular
yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through movements: -
ANSWERS2 and 6
END OF CHAPTER QUESTIONS AND
ANSWERS 2025/2026
, What is the primary function of the IMSA? - ANSWERSSafety education
IMSA stands for: - ANSWERSInternational Municipal Signal Association
Which of the following is NOT an IMSA certification? - ANSWERSY: Traffic Signal Level
II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - ANSWERSOverhead and
underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - ANSWERSCircular red, circular green
PPE stands for: - ANSWERSPersonal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of
aerial lift equipment? - ANSWERSFull body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
ANSWERSEnsure advance warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - ANSWERSY:
Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason
not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic
Control Signals: - ANSWERSThree-section traffic signal with circular red, circular
yellow, and smaller circular yellow indications
The following phases are typically assigned to the major street through movements: -
ANSWERS2 and 6
