PACE Exam Questions And Answers With Complete
Solutions
- increase speed
- turn on all aircraft lights
- look in both directions for traffic
- Callout "clear to cross runway xx" and wait for the pilot
monitoring to respond Correct Answers Prior to crossing a
runway the pilot flying should. (Select all that apply)
100 kts. Correct Answers At what airspeed should ground
reference maneuvers be performed in the C-172?
1200 Correct Answers If Air Traffic Control advises that radar
service is terminated when the pilot is departing Class C
airspace, the transponder should be set to code
122.85 Correct Answers What is the common frequency used
in the North practice area to make position reports?
123.5 Correct Answers What is the common frequency used in
the South practice area to make position reports?
1500 AGL Correct Answers According to the ERAU SOPM,
the minimum recovery altitude for practicing an emergency
descent is
200 Correct Answers On a standard day, the RPM should drop
no more than ____ RPM when running the engine on one
magneto.
,3 Correct Answers All courses have a limit of ___ unexcused
absences. Any no-show that occurs after that number of
unexcused no-show is not eligible for petitioning with the
FPCB. A student may be allowed to continue in a course after
that number of no-shows only at the discretion of the Chief
Flight Instructor, or Department Chairman.
3 statute miles Correct Answers What is the minimum
visibility for a pilot to receive a land and hold short (LAHSO)
clearance?
30 days Correct Answers The Pilot Qualification (PQ) card is
valid for ______ days after which a new PQ card must be issued
and on which any modification is prohibited:
30 degrees Correct Answers Power-Off Stalls are completed
with flaps at what position?
30 to 45 Correct Answers In order to maintain positive load
factors on the aircraft when initiating an emergency descent, the
pilot should bank approximately ____ degrees.
3000 agl Correct Answers What is the minimum altitude for
performing slow flight and stalls while on a solo flight?
3nm, 5nm Correct Answers How far out from the shoreline are
you limited in a single engine airplane? In a multi-engine
airplane?
, 50% Correct Answers In order to use your iPad as an
Electronic Flight Bag for a local flight the battery must have a
minimum of?
65 KIAS Correct Answers What is the final approach speed
for a normal approach and landing in the Cessna Skyhawk?
68 KIAS Correct Answers Best glide speed for the Cessna 172
is
A detailed rundown of each checklist and explains how each
step should be accomplished Correct Answers Part 1 of the
Standard Operating Procedures and Maneuvers provides
above the ground Correct Answers Ground reference
maneuvers should be performed between 600 and 1000 feet
affirmative Correct Answers Air traffic control has asked if
you are able to accept a short approach. The most appropriate
answer, if able, would be:
After we've been cleared to takeoff or line up and wait, but
before entering the runway. Correct Answers When do we
perform Final Items?
Aircraft and Equipment Frequency Inspection Form Correct
Answers The PIC must verify that all required inspections have
been performed and will not become due during the course of
the planned flight by comparing the _______________ to the
Aircraft Time Record.
Solutions
- increase speed
- turn on all aircraft lights
- look in both directions for traffic
- Callout "clear to cross runway xx" and wait for the pilot
monitoring to respond Correct Answers Prior to crossing a
runway the pilot flying should. (Select all that apply)
100 kts. Correct Answers At what airspeed should ground
reference maneuvers be performed in the C-172?
1200 Correct Answers If Air Traffic Control advises that radar
service is terminated when the pilot is departing Class C
airspace, the transponder should be set to code
122.85 Correct Answers What is the common frequency used
in the North practice area to make position reports?
123.5 Correct Answers What is the common frequency used in
the South practice area to make position reports?
1500 AGL Correct Answers According to the ERAU SOPM,
the minimum recovery altitude for practicing an emergency
descent is
200 Correct Answers On a standard day, the RPM should drop
no more than ____ RPM when running the engine on one
magneto.
,3 Correct Answers All courses have a limit of ___ unexcused
absences. Any no-show that occurs after that number of
unexcused no-show is not eligible for petitioning with the
FPCB. A student may be allowed to continue in a course after
that number of no-shows only at the discretion of the Chief
Flight Instructor, or Department Chairman.
3 statute miles Correct Answers What is the minimum
visibility for a pilot to receive a land and hold short (LAHSO)
clearance?
30 days Correct Answers The Pilot Qualification (PQ) card is
valid for ______ days after which a new PQ card must be issued
and on which any modification is prohibited:
30 degrees Correct Answers Power-Off Stalls are completed
with flaps at what position?
30 to 45 Correct Answers In order to maintain positive load
factors on the aircraft when initiating an emergency descent, the
pilot should bank approximately ____ degrees.
3000 agl Correct Answers What is the minimum altitude for
performing slow flight and stalls while on a solo flight?
3nm, 5nm Correct Answers How far out from the shoreline are
you limited in a single engine airplane? In a multi-engine
airplane?
, 50% Correct Answers In order to use your iPad as an
Electronic Flight Bag for a local flight the battery must have a
minimum of?
65 KIAS Correct Answers What is the final approach speed
for a normal approach and landing in the Cessna Skyhawk?
68 KIAS Correct Answers Best glide speed for the Cessna 172
is
A detailed rundown of each checklist and explains how each
step should be accomplished Correct Answers Part 1 of the
Standard Operating Procedures and Maneuvers provides
above the ground Correct Answers Ground reference
maneuvers should be performed between 600 and 1000 feet
affirmative Correct Answers Air traffic control has asked if
you are able to accept a short approach. The most appropriate
answer, if able, would be:
After we've been cleared to takeoff or line up and wait, but
before entering the runway. Correct Answers When do we
perform Final Items?
Aircraft and Equipment Frequency Inspection Form Correct
Answers The PIC must verify that all required inspections have
been performed and will not become due during the course of
the planned flight by comparing the _______________ to the
Aircraft Time Record.
