BMW members Exam Complete Questions And Answers
The reading on the micrometer shown above is ? the clock spring
- -6.5mm
A vehicle has an overheated left front rotor during
What causes brake pulsation? - -Variation driving. What could be the cause? - -
thickness of brake rotor Seized front left caliper piston
A wheel bearing can cause a DSC fault. True or DCS equipped vehicles use a system to choke or
False? - -True drop the RPM in the engine. True or false? -
-True
3 wheel shows 24 miles and 1 is 23, what can be
the cause? - -Bad wheel bearing On a DSC equipped vehicle, Technician A says it
receives inputs from the steering angle sensor.
Technician B says it receives inputs from the
In a parallel circuit it shows three bulbs that brake switch. - -Both
aren't operating. What can be the cause ? -
-Open from Y TO Z
DSC equipped vehicle deactivates traction when
it's cold outside. True or false? - -False
An XDrive vehicle equipped with a transfer case
makes a clunking noise during accelerating and
braking. What could be the cause? - - 0.1 ohms is shown at the injectors. What could
Loose Chain be the cause? - -Short injector
A vehicle comes in with a faulty differential. The A vehicle with a spongy pedal with leaking fluid
fluid is overfilled and creamy, what could be the slowly sinks to the floor. What could be the
cause? - -Water in the fluid cause? - -Primary seal is bad
A vehicle comes in with a concern of a clunking A vehicle comes in with a concert of stiff pedal
sound from the rear during a braking and when pressing rapidly. What could be the cause?
accelerating. What is the most likely cause? - - -Check valve
-Thrust Arm
When you press the brake pedal in and it
A circuit shows a radio that is inoperative on the releases the brake booster hard. What could be
power outlet side. What could be the cause? - the cause? - -Vent port
-Bad Fuse
A diagram shows 50 on one end and 110 on the
A circuit shows the horn is inoperative. What other with different alignment angles. What would
could be the cause? - -High resistance on it cause? - -Pulling to the left
1/2
The reading on the micrometer shown above is ? the clock spring
- -6.5mm
A vehicle has an overheated left front rotor during
What causes brake pulsation? - -Variation driving. What could be the cause? - -
thickness of brake rotor Seized front left caliper piston
A wheel bearing can cause a DSC fault. True or DCS equipped vehicles use a system to choke or
False? - -True drop the RPM in the engine. True or false? -
-True
3 wheel shows 24 miles and 1 is 23, what can be
the cause? - -Bad wheel bearing On a DSC equipped vehicle, Technician A says it
receives inputs from the steering angle sensor.
Technician B says it receives inputs from the
In a parallel circuit it shows three bulbs that brake switch. - -Both
aren't operating. What can be the cause ? -
-Open from Y TO Z
DSC equipped vehicle deactivates traction when
it's cold outside. True or false? - -False
An XDrive vehicle equipped with a transfer case
makes a clunking noise during accelerating and
braking. What could be the cause? - - 0.1 ohms is shown at the injectors. What could
Loose Chain be the cause? - -Short injector
A vehicle comes in with a faulty differential. The A vehicle with a spongy pedal with leaking fluid
fluid is overfilled and creamy, what could be the slowly sinks to the floor. What could be the
cause? - -Water in the fluid cause? - -Primary seal is bad
A vehicle comes in with a concern of a clunking A vehicle comes in with a concert of stiff pedal
sound from the rear during a braking and when pressing rapidly. What could be the cause?
accelerating. What is the most likely cause? - - -Check valve
-Thrust Arm
When you press the brake pedal in and it
A circuit shows a radio that is inoperative on the releases the brake booster hard. What could be
power outlet side. What could be the cause? - the cause? - -Vent port
-Bad Fuse
A diagram shows 50 on one end and 110 on the
A circuit shows the horn is inoperative. What other with different alignment angles. What would
could be the cause? - -High resistance on it cause? - -Pulling to the left
1/2
