NRA Pistol Shooting Exam Questions and Answers

NRA Pistol Shooting Exam Questions and Answers These are the three major components of a pistol - Answer-What are the frame, barrel, and action This is the cylinder - Answer-What is the part of a revolver where cartridges are held in a circular pattern This is the trigger mechanism - Answer-What releases a spring-powered hammer or striker to fire the cartridge These are the elements or stages of aiming - Answer-What are sight alignment and sight picture Where to focus while aiming - Answer-What is unique about the front sight in aiming This is how to ensure you use the correct ammunition for your gun - Answer-What use is the information on the barrel or slide, the owner's manual, and the cartridge box and headstamp This is what to do upon a misfire or hangfire: i.e. when a cartridge fails to fire immediately - Answer-Why would one keep the pistol pointed in a safe direction and wait at least 30 seconds before opening the action and removing the cartridge This is a best-practice for gripping a pistol - Answer-Why use the same pistol grip each time you hold the pistol This is the reason follow-through is important - Answer-Why continue all shooting fundamentals before, during, and immediately after firing a shot This is the frame of the pistol - Answer-What is the central component of a pistol and made of steel, aluminum, titanium, or polymer materials These are the components of a pistol cartridge - Answer-What is made of a case, primer, powder, and bullet These are the two types of revolver actions - Answer-What are single and double action To what does 'double action' refer - Answer-What is the type of action in which pulling the trigger performs two tasks: cocking and releasing the hammer Do this before cleaning a pistol - Answer-When to unload, remove ammunition from the area, and follow the owner's manual This occurs when a cartridge fails to fire after the primer has been struct by the firing pin - Answer-What is a misfire This is the 'safety' - Answer-What is a mechanical device that can fail This minimizes body movement - Answer-Why hold your breath during breath control This involves practicing the firing process using an unloaded firearm - Answer-What is dry firing This is the basic rule of sight alignment - Answer-Why move the rear sight opposite the direction you want to hits on the target to move This is the technique of pulling the trigger without causing movement of the aligned sights - Answer-What is trigger control This is produced as gun powder burns - Answer-What produces high pressure gas that moves a bullet down the barrel These are elements of a good shooting position - Answer-What good are consistency, balance, support, natural aiming area, and comfort This is having the top of the sights aligned and the front sight centered - Answer-What is proper sight alignment This results from less than normal pressure of velocity after ignition of the cartridge - Answer-What is a squib load This is how to make a gun more reliable, accurate, and last longer - Answer-What results when a gun is properly maintained Always do this - Answer-When to keep a gun pointed in a safe direction This is a safety - Answer-What is a mechanical device that can fail This is a place not accessible to unauthorized persons - Answer-Where do you store a pistol This is a perceptible delay in the ignition of a cartridge after the primer has been struck - Answer-What is a hangfire This is not true of pistol cartridges - Answer-What can be fired from any handgun This is a single-action pistol - Answer-What pistol design has a trigger perform only one action These are +P cartridges - Answer-What cartridges are loaded to higher pressure than standard Do this with unserviceable ammunition - Answer-When to return ammunition to the manufacturer or to a hazardous disposal center This is when to keep your finger off the trigger - Answer-Do this until you are prepared to shoot This is essential for accurate shooting - Answer-What is grip consistency This should not be present around a pistol - Answer-What is ammunition during cleaning