Unitized Body Structural Repair
Study online at https://quizlet.com/_evuj65
1. which statement describes UHSS (ultra-high Can be heater following manu-
strength steel) facturer's recommendations
2. If a manufacturer places a three minute time lim- for a total of 3 mins
it on heating HSS (ultra-high strength steel), this
means that heat can be applied
3. heat crayons indicate their rated temp when they melt
4. HSS parts should be replaced if they are kinked
5. if an overpull occurs the part generally must be re-
placed
6. tensile straight is the amount of pressure or force tear
required to cause a
7. HSS can be identified by referring to the body repair
manual
8. unibody structural panels should be welded by mig welding
which of the following methods
9. the recommended shielding gas for welding steels 75% AR/ 25% CO2
in collision repair is
10. porosity in the mig weld may be due to lack of shielding gas
11. metal distortion and tearing during pulling can be using multiple pulls
minimized by
12. which of the following uses heat by an electric arc flux coated
to fuse base metal in a weld joint
13. all of the above
1/3
Study online at https://quizlet.com/_evuj65
1. which statement describes UHSS (ultra-high Can be heater following manu-
strength steel) facturer's recommendations
2. If a manufacturer places a three minute time lim- for a total of 3 mins
it on heating HSS (ultra-high strength steel), this
means that heat can be applied
3. heat crayons indicate their rated temp when they melt
4. HSS parts should be replaced if they are kinked
5. if an overpull occurs the part generally must be re-
placed
6. tensile straight is the amount of pressure or force tear
required to cause a
7. HSS can be identified by referring to the body repair
manual
8. unibody structural panels should be welded by mig welding
which of the following methods
9. the recommended shielding gas for welding steels 75% AR/ 25% CO2
in collision repair is
10. porosity in the mig weld may be due to lack of shielding gas
11. metal distortion and tearing during pulling can be using multiple pulls
minimized by
12. which of the following uses heat by an electric arc flux coated
to fuse base metal in a weld joint
13. all of the above
1/3