Exam Rev
.0034 x diameter (inches) squared x L (inches) - ANS-Capacity (gallons) =
.0408 x diameter (inches) squared x L (toes) - ANS-Capacity (gallons) =
.25 inches - ANS-Minimum size floor drain strainer starting is:
.434 * eighty two = 35.Fifty nine psi - ANS-What is the stress in pounds at the bottom of a
stack eighty two' excessive?
"V" zone (challenge to wave heights in excess of three') - ANS-High Hazard flood sector is:
$1,000 - ANS-You want to pay the prevailing salary on nation jobs when you are over what
Amount?
Zero.One hundred twenty five inches - ANS-A lead pour when caulked shall not recede
zero.2% Lead - ANS-Lead unfastened solder and flux comprise no more than
zero.5 inches - ANS-Strainer plates on drain strains for rodent proofing must have openings:
1 - ANS-Drainage Fixture Unit on Lav
1 half" - ANS-Minimum size moist vent piping is:
1 half of" - ANS-Shower waste shops will be minimum of:
1 half" - ANS-What is the minimal length outlet for a bath in RI?
1 1/four" - ANS-The minimum length vent in RI is ____________.
1 gallon - ANS-How many gallons does a urinal use for the duration of a flush cycle?
1-1/4" - ANS-Phenuematic Vent size for Sewage Pumps
1.Five" deep with a 3/4" drain - ANS-Water heater pan length and drain length is:
half of Roof Area - ANS-How many feet does a roof ledge or vertical wall add to roof vicinity
half" OD - ANS-What is the minimal supply tube to a one-piece rest room?
, 1/4" - ANS-Minimum pitch for two half" piping and smaller is:
10 - ANS-A grasp plumber employs 3 grasp plumbers, and 6 journeyman. How many
apprentices can he have.
10 Feet - ANS-How some distance does sanitary vent need to be from belongings line
10' and a pair of' - ANS-A vent which extrudes out the side of a building ought to be as a
minimum _______ and ______ faraway from doorways and home windows.
10' and 2' - ANS-Vent from window Can be How many feet from window horizontally and
vertically
10' head - ANS-Water testing of a drainage machine requires a:
10' undisturbed compacted earth - ANS-Water provider piping and building drain/sewer will
be separated through:
a hundred Feet - ANS-Cleanouts for horizontal drains and building sewers 6" and smaller will
be placed every:
one hundred psi @180 tiers - ANS-All hot water distribution piping and tubing shall have a
minimum strain rating of:
a hundred and ten degrees - ANS-Hot water is water at temperature greater than or same to:
one hundred ten Degrees - ANS-In RI warm water is _________ stages.
12 ounces in step with rectangular foot - ANS-Sheet copper shall not weigh less than:
one hundred twenty degrees - ANS-Shower and Tub/Shower valves most hot water putting
is:
one hundred forty tiers - ANS-Maximum water temperature of a tankless heater or home hot
water heater is:
a hundred and forty four (X=62.5/.434) - ANS-6" pipe with sixty two.5 psi. How many toes of
head stress?
15" - ANS-Water closets, bidets or toilets shall have a clearance from center of fixture to wall
of:
one hundred sixty psi - ANS-Minimum operating strain of a domestic water carrier either
outdoor or buried is:
18-forty two" Min 2" - ANS-Laundry Stand Pipe