OSHA #510
A *material chute* used during demolition operations must be _____ when its angle is *equal to
or greater than 45 degrees* - ANS - Entirely enclosed
\All portable ladders must have a minimum clearance distance between the side rails of ______
inches. - ANS - 11 1/2"
\Details of the OSHA inspection process can be found in *which section* of 29 CFR? List the 4
steps of the OSHA inspection process: - ANS - 1903.1 Page 1
-Display official credentials
-Opening conferences
-Walk around inspection
-Closing conference
\Guarding against accidental contact is required for electrical equipment operating at ____ volts
or higher - ANS - 50 Volts
\Horizontal standards apply to workplace conditions that: - ANS - When a condition is not
covered by a specific industry standard
\How should the personal fall arrest system (PFAS) be rigged, i.e. what are the free fall limits? -
ANS - An employee cannot free fall more than *6 feet* on contact any lower level
\If a competent person cannot determine if a damaged trench shield is able to support its
intended load, the trench shield should be removed from service until _____ - ANS - Register
professional engineering approval
\If an employee is obsessed with chipping concrete with a demo hammer that has a damaged
electrical cord, then the demo hammer should be tagged and removed from service according
to what standard? - ANS - 1926.404 (b)(1)(iii)
\In OSHA recordkeeping, the calculation of the number of recordable injuries and illnesses per
100 full-time workers is known as: - ANS - Incident rate
\In reference to the conduction of hand and power tools, what is required of all hand and power
tools, regardless of who paid them? - ANS - Maintained in safe condition
\In the *absence* of an ____,____,____ or ______, that is reasonably accessible in terms of
time and distance from the worksite, the employer shall make sure a person with a valid first air
training certificate is available at the worksite. - ANS - Pharmacy
Clinic
Hospital
Physician
\In the event one has been removed, what is the requirement for remounting a Rollover
Protective Structure (ROPS)? - ANS - Remounting with equal quality or better bolts or welding
as required for the original mounting
\List the hierarchy for controlling overexposure to chemical hazards. - ANS - -Engineering
-Administrative Control
-PPE
A *material chute* used during demolition operations must be _____ when its angle is *equal to
or greater than 45 degrees* - ANS - Entirely enclosed
\All portable ladders must have a minimum clearance distance between the side rails of ______
inches. - ANS - 11 1/2"
\Details of the OSHA inspection process can be found in *which section* of 29 CFR? List the 4
steps of the OSHA inspection process: - ANS - 1903.1 Page 1
-Display official credentials
-Opening conferences
-Walk around inspection
-Closing conference
\Guarding against accidental contact is required for electrical equipment operating at ____ volts
or higher - ANS - 50 Volts
\Horizontal standards apply to workplace conditions that: - ANS - When a condition is not
covered by a specific industry standard
\How should the personal fall arrest system (PFAS) be rigged, i.e. what are the free fall limits? -
ANS - An employee cannot free fall more than *6 feet* on contact any lower level
\If a competent person cannot determine if a damaged trench shield is able to support its
intended load, the trench shield should be removed from service until _____ - ANS - Register
professional engineering approval
\If an employee is obsessed with chipping concrete with a demo hammer that has a damaged
electrical cord, then the demo hammer should be tagged and removed from service according
to what standard? - ANS - 1926.404 (b)(1)(iii)
\In OSHA recordkeeping, the calculation of the number of recordable injuries and illnesses per
100 full-time workers is known as: - ANS - Incident rate
\In reference to the conduction of hand and power tools, what is required of all hand and power
tools, regardless of who paid them? - ANS - Maintained in safe condition
\In the *absence* of an ____,____,____ or ______, that is reasonably accessible in terms of
time and distance from the worksite, the employer shall make sure a person with a valid first air
training certificate is available at the worksite. - ANS - Pharmacy
Clinic
Hospital
Physician
\In the event one has been removed, what is the requirement for remounting a Rollover
Protective Structure (ROPS)? - ANS - Remounting with equal quality or better bolts or welding
as required for the original mounting
\List the hierarchy for controlling overexposure to chemical hazards. - ANS - -Engineering
-Administrative Control
-PPE
