Broadband digital installer conventional questions
with accurate answers
A cable gateway can replace which broadband cable operator supplied
devices? Ans✓✓✓ The cable gateway could replace a cable modem
A constant bit rate telephone system is considered to be circuit switching
technology, because the analog audio signal is Ans✓✓✓ Converted into
a digital DSO circuit and switched to other cable, telephone customers,
or to the telephone companies Netwerk
A modular plug contains 4,6 or eight pin positions each position is
numbered and is used to terminate a specific tip or ring wire from a quad
or twisted pair cable. How are the pins on a modular Jack numbered
Ans✓✓✓ From left to right, with the locking tab down
According to article 800-154 of the 2005NEC what are the types of UTP
cable and their applications? Ans✓✓✓ According to article 800-154 of
the 2005 NEC the following are the UTP cable types and other
applications. CM is general-purpose indoor cable CMX is indoor and
outdoor cable with UV protection CMR is riser rated cable and CMP is
Plenum rated cable.
After mounting and wiring, a new modular, telephone jack in a star
installation, where should the unshielded twisted pair cable from the new
modular Jack be connected? Ans✓✓✓ To the tip and ring, screw,
terminals or insulation displacement connection on the telephone
distribution device
,After mounting and wiring, a new modular, telephone jack in a star
topology, what is wired last? Ans✓✓✓ After mounting and wiring, a
new modular, telephone, jack, why are the twisted pair conductor wire
of the UTP cable that was rotted and attached to the newly added
modular telephone jack to the telephone distribution device
After verifying the dial tone from the MTA, what is the next step in
verifying the MTAs operational status Ans✓✓✓ Checking that the
MTA dials and connects properly by making local and long-distance
calls
All telephone cables are labeled with either a level or category number,
but designates the cable performance criteria. How do CAT 1,2,3
compare to cat5e Ans✓✓✓ CAT 1-3 are used only for voice
applications cat5e and higher are used for voice and data
During any cabling operation, how do you protect the public at work,
your test, equipment, and the customer premise equipment? Ans✓✓✓
To protect the public Netwerk, your test equipment, and the customer
premise equipment, disconnect, the customer, promise cabling at the
demarcation point, or auxiliary disconnect outlet before starting any
cabling operations
During DOCSIS modem registration. When does the DOCSIS modem
become sanction for high speed data service at the authorized service
levels. Ans✓✓✓ The DOCSIS modem become sanctioned for HST
service at authorized service levels after a registration response message
is sent to the DOCSIS modem and the DOCSIS modem is assigned a
service identifier
, Entertainment cabinet with doors made of green glass block which of the
following from electronic components Ans✓✓✓ Infrared IR remote
sensors
For an embedded media terminal adapter to receive an authorization key
for telephone service what is required of the M•A•C address? Ans✓✓✓
It must be assigned to a customer account in the billing system database,
which updates the cable modem termination system
Generally speaking, A WAN can be described as Ans✓✓✓ A network
comprised of several local area networks and metropolitan area networks
interconnected into a single Netwerk covering a large geographic area
Generating a dial tone in either a traditional telephone call or a
packetcable voice over internet protocol is similar, except Ans✓✓✓
Equipment in the central office for plain old telephone service since is
the change in voltage and generates a dialtone where the inventor
multimedia terminal adapter since is the change and generates a dial tone
in packetcable
How are Internet protocol and modem configuration information sent to
a DOCSIS modem Ans✓✓✓ How do you pee and modem
configuration information originate with a provisioning server and are
sent to the DOCSIS modem through the cable modem termination
system in a proxy agreement
with accurate answers
A cable gateway can replace which broadband cable operator supplied
devices? Ans✓✓✓ The cable gateway could replace a cable modem
A constant bit rate telephone system is considered to be circuit switching
technology, because the analog audio signal is Ans✓✓✓ Converted into
a digital DSO circuit and switched to other cable, telephone customers,
or to the telephone companies Netwerk
A modular plug contains 4,6 or eight pin positions each position is
numbered and is used to terminate a specific tip or ring wire from a quad
or twisted pair cable. How are the pins on a modular Jack numbered
Ans✓✓✓ From left to right, with the locking tab down
According to article 800-154 of the 2005NEC what are the types of UTP
cable and their applications? Ans✓✓✓ According to article 800-154 of
the 2005 NEC the following are the UTP cable types and other
applications. CM is general-purpose indoor cable CMX is indoor and
outdoor cable with UV protection CMR is riser rated cable and CMP is
Plenum rated cable.
After mounting and wiring, a new modular, telephone jack in a star
installation, where should the unshielded twisted pair cable from the new
modular Jack be connected? Ans✓✓✓ To the tip and ring, screw,
terminals or insulation displacement connection on the telephone
distribution device
,After mounting and wiring, a new modular, telephone jack in a star
topology, what is wired last? Ans✓✓✓ After mounting and wiring, a
new modular, telephone, jack, why are the twisted pair conductor wire
of the UTP cable that was rotted and attached to the newly added
modular telephone jack to the telephone distribution device
After verifying the dial tone from the MTA, what is the next step in
verifying the MTAs operational status Ans✓✓✓ Checking that the
MTA dials and connects properly by making local and long-distance
calls
All telephone cables are labeled with either a level or category number,
but designates the cable performance criteria. How do CAT 1,2,3
compare to cat5e Ans✓✓✓ CAT 1-3 are used only for voice
applications cat5e and higher are used for voice and data
During any cabling operation, how do you protect the public at work,
your test, equipment, and the customer premise equipment? Ans✓✓✓
To protect the public Netwerk, your test equipment, and the customer
premise equipment, disconnect, the customer, promise cabling at the
demarcation point, or auxiliary disconnect outlet before starting any
cabling operations
During DOCSIS modem registration. When does the DOCSIS modem
become sanction for high speed data service at the authorized service
levels. Ans✓✓✓ The DOCSIS modem become sanctioned for HST
service at authorized service levels after a registration response message
is sent to the DOCSIS modem and the DOCSIS modem is assigned a
service identifier
, Entertainment cabinet with doors made of green glass block which of the
following from electronic components Ans✓✓✓ Infrared IR remote
sensors
For an embedded media terminal adapter to receive an authorization key
for telephone service what is required of the M•A•C address? Ans✓✓✓
It must be assigned to a customer account in the billing system database,
which updates the cable modem termination system
Generally speaking, A WAN can be described as Ans✓✓✓ A network
comprised of several local area networks and metropolitan area networks
interconnected into a single Netwerk covering a large geographic area
Generating a dial tone in either a traditional telephone call or a
packetcable voice over internet protocol is similar, except Ans✓✓✓
Equipment in the central office for plain old telephone service since is
the change in voltage and generates a dialtone where the inventor
multimedia terminal adapter since is the change and generates a dial tone
in packetcable
How are Internet protocol and modem configuration information sent to
a DOCSIS modem Ans✓✓✓ How do you pee and modem
configuration information originate with a provisioning server and are
sent to the DOCSIS modem through the cable modem termination
system in a proxy agreement
