_____________Quiz____________?
The maximum compressive stress a material can withstand without failure. -
Answer✓✓
Compression Strength
_____________Quiz____________?
A solid, hard material produced by combining Portland cement, aggregates, sand, water and
sometimes additional mixtures. -
Answer✓✓
Concrete
_____________Quiz____________?
The difference between the indoor temperature in winter and the outdoor design temperature
in winter. The design temperature differential or design range is used in calculating the space
heating requirements of a dwelling unit under the engineering-based methodology. -
Answer✓✓
Design Temperature Differential
1
,_____________Quiz____________?
The finish board covering the edges of rafters and eaves. -
Answer✓✓
Fascia
_____________Quiz____________?
The lowest, widest part of the foundation that distributes the load over a broad area of the soil.
-
Answer✓✓
Footing
_____________Quiz____________?
The lower part of a building, which transfers structural loads from the building to the soil. -
Answer✓✓
Foundation
_____________Quiz____________?
The energy needed to warm outside air leaking into a building through cracks around doors,
windows, and other areas. -
Answer✓✓
Heat Loss
_____________Quiz____________?
2
, Energy radiated or transmitted as rays or waves, in the form of particles. -
Answer✓✓
Radiant Heat
_____________Quiz____________?
Member of a roof structural frame that supports the sheathing and other roof loads. -
Answer✓✓
Rafter
_____________Quiz____________?
Steel bar used to reinforce concrete. -
Answer✓✓
Rebar
_____________Quiz____________?
The numerical value used to indicate the resistance to the flow of heat. -
Answer✓✓
R-Value
_____________Quiz____________?
The plate placed at the bottom of a wall. -
Answer✓✓
Sole Plate
3
The maximum compressive stress a material can withstand without failure. -
Answer✓✓
Compression Strength
_____________Quiz____________?
A solid, hard material produced by combining Portland cement, aggregates, sand, water and
sometimes additional mixtures. -
Answer✓✓
Concrete
_____________Quiz____________?
The difference between the indoor temperature in winter and the outdoor design temperature
in winter. The design temperature differential or design range is used in calculating the space
heating requirements of a dwelling unit under the engineering-based methodology. -
Answer✓✓
Design Temperature Differential
1
,_____________Quiz____________?
The finish board covering the edges of rafters and eaves. -
Answer✓✓
Fascia
_____________Quiz____________?
The lowest, widest part of the foundation that distributes the load over a broad area of the soil.
-
Answer✓✓
Footing
_____________Quiz____________?
The lower part of a building, which transfers structural loads from the building to the soil. -
Answer✓✓
Foundation
_____________Quiz____________?
The energy needed to warm outside air leaking into a building through cracks around doors,
windows, and other areas. -
Answer✓✓
Heat Loss
_____________Quiz____________?
2
, Energy radiated or transmitted as rays or waves, in the form of particles. -
Answer✓✓
Radiant Heat
_____________Quiz____________?
Member of a roof structural frame that supports the sheathing and other roof loads. -
Answer✓✓
Rafter
_____________Quiz____________?
Steel bar used to reinforce concrete. -
Answer✓✓
Rebar
_____________Quiz____________?
The numerical value used to indicate the resistance to the flow of heat. -
Answer✓✓
R-Value
_____________Quiz____________?
The plate placed at the bottom of a wall. -
Answer✓✓
Sole Plate
3
