FLORIDA LP GAS & RULES EVALUATION EXAMS 2025/2026
QUESTIONS WITH ANSWERS RATED A+
✔✔With appliances connected, the entire system shall be pressurized to not less than
________________ and measure for a period of _________ minutes.
A) 3 p.s.i. , 10
B) 125 p.s.., 10
C) 3 p.s.i, 4
D) 8 p.s.i., 4 - ✔✔A) 3 p.s.i, 10
✔✔Fuel buring appliances shall be listed for installation in RV.
A) True
B) False - ✔✔A) True
✔✔This type of valve will always remain closed except when fuel flow from outside
forces it open (as happens during the filling process) - ✔✔Fill Valve or Back flow check
valve
✔✔This valve permits flow of gas in either direction but closes automatically when the
outward gas flow exceeds a safe rate - ✔✔Excess flow check valve
✔✔External type or internal type, these valves are held closed by a spring unless the
tank's internal pressure becomes higher than the maximum working pressure. -
✔✔Pressure releif valve
✔✔This valve has a integral excess flow check valve and is used primarly in motor fuel
application such as forklift turcks - ✔✔Liquid Service Valve
✔✔Service valve with built-in pressure relief for vapor withdrawal from cylinder. This
valve should be plugged or capped whenever the container is disconnected from use.
Always check the pressure relief valve for damage before filling. - ✔✔POL Valve
✔✔Guages are devices which indicate the percentage of gas in a container based on
an internal float located at and moving with the liquid inside the tank. NOT to be used as
a guide for filling containers - ✔✔Magnetic float gauge
✔✔The gauge is used during the filling process to determine when the container is filled
to 80% full. A tube attached to the valve is in communication with the vapor space of the
container. When the container is at 80%, liquid will go through the tube and bleed
through the guage when open. This gauge is to remain closed except when filling a
container. - ✔✔Fixed Liquid Level Gauge
, ✔✔The valve found on all DOT cylinders between 4 and 40 lbs. - ✔✔Overfill prevention
device OPD
✔✔OPD is an approved method of filling a container.
A) True
B) False - ✔✔B) False
✔✔What signage is required to be prominently posted at the transfer location of a
dispensing location?
A) Exit map
B) License number
C) Proper filling instructions
D) Video Recording Installed - ✔✔C) Proper filling instructions
✔✔Other than a 18# BC fire extinguisher, what other method of control is acceptable for
handling propane emergencies?
A) wet blanket
B) Large quantities of water
C) blast of air
D) None of the Above - ✔✔B) Large quantities of water
✔✔ Licensed Locations Qualifier:
A) Full Time Employee
B) Non-Supervisory Position
C) Multiple Locations
D) All of the Above - ✔✔A) Full Time Employee
✔✔Vacancies in Qualifier must be reported:
A) By the qualifier
B) By the licensed company
C) 20 Working Days
D) 60 Working Days
E) All of the above - ✔✔E) All of the above
✔✔Is the Bureau of Compliance is currently responsible for licensing, exams and
training.
A) True
B) False - ✔✔A) True
✔✔Qualifier means any business who has passed a competency examination
administrated by the department and is employed by a licensed Cat I, II, V business.
A) True
B) False - ✔✔B) False
QUESTIONS WITH ANSWERS RATED A+
✔✔With appliances connected, the entire system shall be pressurized to not less than
________________ and measure for a period of _________ minutes.
A) 3 p.s.i. , 10
B) 125 p.s.., 10
C) 3 p.s.i, 4
D) 8 p.s.i., 4 - ✔✔A) 3 p.s.i, 10
✔✔Fuel buring appliances shall be listed for installation in RV.
A) True
B) False - ✔✔A) True
✔✔This type of valve will always remain closed except when fuel flow from outside
forces it open (as happens during the filling process) - ✔✔Fill Valve or Back flow check
valve
✔✔This valve permits flow of gas in either direction but closes automatically when the
outward gas flow exceeds a safe rate - ✔✔Excess flow check valve
✔✔External type or internal type, these valves are held closed by a spring unless the
tank's internal pressure becomes higher than the maximum working pressure. -
✔✔Pressure releif valve
✔✔This valve has a integral excess flow check valve and is used primarly in motor fuel
application such as forklift turcks - ✔✔Liquid Service Valve
✔✔Service valve with built-in pressure relief for vapor withdrawal from cylinder. This
valve should be plugged or capped whenever the container is disconnected from use.
Always check the pressure relief valve for damage before filling. - ✔✔POL Valve
✔✔Guages are devices which indicate the percentage of gas in a container based on
an internal float located at and moving with the liquid inside the tank. NOT to be used as
a guide for filling containers - ✔✔Magnetic float gauge
✔✔The gauge is used during the filling process to determine when the container is filled
to 80% full. A tube attached to the valve is in communication with the vapor space of the
container. When the container is at 80%, liquid will go through the tube and bleed
through the guage when open. This gauge is to remain closed except when filling a
container. - ✔✔Fixed Liquid Level Gauge
, ✔✔The valve found on all DOT cylinders between 4 and 40 lbs. - ✔✔Overfill prevention
device OPD
✔✔OPD is an approved method of filling a container.
A) True
B) False - ✔✔B) False
✔✔What signage is required to be prominently posted at the transfer location of a
dispensing location?
A) Exit map
B) License number
C) Proper filling instructions
D) Video Recording Installed - ✔✔C) Proper filling instructions
✔✔Other than a 18# BC fire extinguisher, what other method of control is acceptable for
handling propane emergencies?
A) wet blanket
B) Large quantities of water
C) blast of air
D) None of the Above - ✔✔B) Large quantities of water
✔✔ Licensed Locations Qualifier:
A) Full Time Employee
B) Non-Supervisory Position
C) Multiple Locations
D) All of the Above - ✔✔A) Full Time Employee
✔✔Vacancies in Qualifier must be reported:
A) By the qualifier
B) By the licensed company
C) 20 Working Days
D) 60 Working Days
E) All of the above - ✔✔E) All of the above
✔✔Is the Bureau of Compliance is currently responsible for licensing, exams and
training.
A) True
B) False - ✔✔A) True
✔✔Qualifier means any business who has passed a competency examination
administrated by the department and is employed by a licensed Cat I, II, V business.
A) True
B) False - ✔✔B) False
