PRACTICE TEST | ACTUAL EXAM
QUESTIONS WITH CORRECT VERIFIED
SOLUTIONS. NEWEST UPDATE.
ALREADY GRADED!!
1) How is true power expressed? - ANSWER ✓ KW
2) You took apart a 3 phase motor, meggered a motor lead to the
housing, and read 5000 ohms. What does this mean? - ANSWER ✓
Motor is fine
3) A 500hp, 3 phase, 460v, 8-pole, 900 rpm motor is connected to a
5:1 gear box. What is the rpm of the output shaft? Forget about
all the needless information. The question gives the rpm of the
motor that's all you need. - ANSWER ✓
4) What drawing does a PLC use? - ANSWER ✓ Ladder
5) What does NFPA820 cover? - ANSWER ✓ Wastewater and
Collections
6) When should you megger a motor for its lowest insulation
readings? - ANSWER ✓ Immediately after shutting down
equipment.
7) In a start stop control circuit, an additional two stop buttons are
to be added. These stop buttons should be installed in which way?
- ANSWER ✓ In series with the existing stop
, 8) Redline drawings are best described as? - ANSWER ✓ A way to
show additional work and changes to the system.
9) Redlines should be used to? - ANSWER ✓ Check the engineers
10) Best way to check a 4-20ma signal? - ANSWER ✓ Place DMM
selector to mA and put leads in series with the circuit.
11) What is the most important step when performing a megger
test? - ANSWER ✓ Put the leads together and verify a direct short
12) A diaphragm type gauge protector is used in which type of
environment? - ANSWER ✓ Corrosive
13) You are the lead on a high priority critical pump repair. Your
co-worker decides it's a good time to take a break. You know that
the job will take ten minutes if you have their help. What should
you do? - ANSWER ✓ A. Do the job yourself.
B. Get someone else to help you.
C. Calmly explain the importance of the job and that once it is
done a break can be taken.
D. Take a break and then do the job.
14) What is the characteristic of resistance in copper wire? -
ANSWER ✓ It is inverse to its cross-sectional area.
15) What is the maximum time between taking a class in
NFPA70E? - ANSWER ✓
16) the most common cause of electrical accidents among those
that work with electricity is? - ANSWER ✓ Contact with overhead