AVIXA CTS Sample| Exam Questions with Correct Solutions| Latest Update Graded A+
After a site visit you realize you forgot to measure the room length. You did measure the
width as 35 feet and ceiling height as 8 feet. Knowing from other documentation that the
room's total area is 980 square feet, what might the length be? 122.5 ft 28 ft 35 ft 280 ft
The brightness controls on a display adjusts which level? Black Level Chroma Level Hue
White Level
Prior to performing a site assessment and new system design you should identify the:
Client's need and intended uses Supplier's equipment recommendations Programmer's fee
requirements Manufacturer's training offerings
Daily maintenance of a wireless microphone system will most likely included this activity:
Checking battery life, and replacing those which are low/dead. Coordinating frequency
allocation with the FCC. Calibrating the mic pre-amp sensitivity. Tuning the delay equalization.
A dimmer rack with a constant load capability is powering twenty-four incandescent lights
during a stage production. The dimmer rack is running on a steady 230 VAC supply and
averaging approximately 98 amps draw. Suddenly the line voltage drops to 211 VAC. Calculate
the expected amperage draw. 107 amps 98 amps 90 amps 120 amps
Projectors may use different lamp technologies for different reasons. For long life without
changing the light source, which technology is preferred? Halogen lamp Fluorescent lamp LED
lamp Arc lamp
An owner representative contests an invoice that was mailed after an emergency service
call which had determined the problem was "operator error". Which of the following is *least*
likely to prevent this type of misunderstanding? The service agreement on file with Owner and
Integrator was referenced when the emergency service call was placed Service agreement
listed out specifics of what's covered, noting emergency and operator error conditions
Predetermine that there is no need for service agreement given predicted mean time between
failure for a TV System operation training was provided at system completion and with
refreshers during maintenance visits
, When striking a room after a live event, what is the BEST way to ensure that nothing gets
missed? Only hire experienced technicians Use a plan of action and a set of checklists In live
events, something always gets missed Have your lead technician doublecheck the room after it
has been struck
It is important to consider polar patterns when______ calibrating the display replacing
batteries in series selecting microphones for use at live events setting up a satellite dish for
reception
A quick and accurate means to estimate dimensions of a commercial space during a site
inspection would be to _____? Count the number of ceiling tiles in a drop tile installation Pace
off number of steps across the room using an average of 3' (1m) per step Utilize your arm span
to measure the walls using an average of 5' 6" (1.5m) Estimate based upon the number of fire
sprinklers
A device is controlled using the pictured cable. What is the MOST LIKELY method of
controlling this device? IR RF RS-232 Network
To maximize the quality of projected images in a presentation, the AV technician should
ensure that there is minimal
color temperature imbalance between the projected image and the ambient light
other media used in the room except the projected image
HDCP fallout
ambient light in the display environment
What is the aspect ratio of a screen that has a height of 29.5 inches (74.9 cm) and a
diagonal of inches 60 inches (152.4 cm)? 16:10 5:4 16:9 4:3
As part of regular system maintenance, when is the BEST time to update device firmware?
On Friday afternoons. As soon as updates are available. Device firmware should never be
, updated after system sign-off. After coordination with the client, and when the system will be
available for an extended period of time
After presenting a proposal to a client, confirming that all objections are answered and that
the final buying decision will be made at an internal meeting, what is the next step? Call once, a
month later Include the client in the corporate e-blasts Communicate regularly, until a decision
is made Wait for the client to email the order
A customer is reporting instances of "distortion" in a recently installed and calibrated audio
system. What is the FIRST thing that should be done? Replace all of the speakers in the system.
Turn the amplifiers to unity gain. Check the gain structure of all audio signals in the system.
Recalibrate all of the acoustic echo cancellers.
Preventative maintenance tasks and intervals are detailed in the ___________. Elevation
drawing Program report Service agreement DISCAS standard
Where is the BEST location for end user training for a newly installed videoconferencing
system? At the integrator's newly completed showroom At the same room that the new system
was installed in At individuals desktops using similar conferencing software At a regional hotel
that's known for excellent food and beverage
A medical center needs to install a display for diagnostic imagery, the space should be
designed according to which viewing category. Passive Viewing Full Motion Video Basic Decision
Making Analytical Decision Making
A field service technician replaces a piece of AV equipment on the client LAN but notices it's
not getting proper IP address. What's the most likely issue? The new piece of equipment needs
to have its MAC registered. The new piece of equipment has a defective USB port. The new
piece of equipment needs HDCP turned on. The new piece of equipment has different
firmware.
An installed audio system should be AT LEAST __________ above the ambient noise floor. 5
dB 25 dB 45 dB 75 dB
After a site visit you realize you forgot to measure the room length. You did measure the
width as 35 feet and ceiling height as 8 feet. Knowing from other documentation that the
room's total area is 980 square feet, what might the length be? 122.5 ft 28 ft 35 ft 280 ft
The brightness controls on a display adjusts which level? Black Level Chroma Level Hue
White Level
Prior to performing a site assessment and new system design you should identify the:
Client's need and intended uses Supplier's equipment recommendations Programmer's fee
requirements Manufacturer's training offerings
Daily maintenance of a wireless microphone system will most likely included this activity:
Checking battery life, and replacing those which are low/dead. Coordinating frequency
allocation with the FCC. Calibrating the mic pre-amp sensitivity. Tuning the delay equalization.
A dimmer rack with a constant load capability is powering twenty-four incandescent lights
during a stage production. The dimmer rack is running on a steady 230 VAC supply and
averaging approximately 98 amps draw. Suddenly the line voltage drops to 211 VAC. Calculate
the expected amperage draw. 107 amps 98 amps 90 amps 120 amps
Projectors may use different lamp technologies for different reasons. For long life without
changing the light source, which technology is preferred? Halogen lamp Fluorescent lamp LED
lamp Arc lamp
An owner representative contests an invoice that was mailed after an emergency service
call which had determined the problem was "operator error". Which of the following is *least*
likely to prevent this type of misunderstanding? The service agreement on file with Owner and
Integrator was referenced when the emergency service call was placed Service agreement
listed out specifics of what's covered, noting emergency and operator error conditions
Predetermine that there is no need for service agreement given predicted mean time between
failure for a TV System operation training was provided at system completion and with
refreshers during maintenance visits
, When striking a room after a live event, what is the BEST way to ensure that nothing gets
missed? Only hire experienced technicians Use a plan of action and a set of checklists In live
events, something always gets missed Have your lead technician doublecheck the room after it
has been struck
It is important to consider polar patterns when______ calibrating the display replacing
batteries in series selecting microphones for use at live events setting up a satellite dish for
reception
A quick and accurate means to estimate dimensions of a commercial space during a site
inspection would be to _____? Count the number of ceiling tiles in a drop tile installation Pace
off number of steps across the room using an average of 3' (1m) per step Utilize your arm span
to measure the walls using an average of 5' 6" (1.5m) Estimate based upon the number of fire
sprinklers
A device is controlled using the pictured cable. What is the MOST LIKELY method of
controlling this device? IR RF RS-232 Network
To maximize the quality of projected images in a presentation, the AV technician should
ensure that there is minimal
color temperature imbalance between the projected image and the ambient light
other media used in the room except the projected image
HDCP fallout
ambient light in the display environment
What is the aspect ratio of a screen that has a height of 29.5 inches (74.9 cm) and a
diagonal of inches 60 inches (152.4 cm)? 16:10 5:4 16:9 4:3
As part of regular system maintenance, when is the BEST time to update device firmware?
On Friday afternoons. As soon as updates are available. Device firmware should never be
, updated after system sign-off. After coordination with the client, and when the system will be
available for an extended period of time
After presenting a proposal to a client, confirming that all objections are answered and that
the final buying decision will be made at an internal meeting, what is the next step? Call once, a
month later Include the client in the corporate e-blasts Communicate regularly, until a decision
is made Wait for the client to email the order
A customer is reporting instances of "distortion" in a recently installed and calibrated audio
system. What is the FIRST thing that should be done? Replace all of the speakers in the system.
Turn the amplifiers to unity gain. Check the gain structure of all audio signals in the system.
Recalibrate all of the acoustic echo cancellers.
Preventative maintenance tasks and intervals are detailed in the ___________. Elevation
drawing Program report Service agreement DISCAS standard
Where is the BEST location for end user training for a newly installed videoconferencing
system? At the integrator's newly completed showroom At the same room that the new system
was installed in At individuals desktops using similar conferencing software At a regional hotel
that's known for excellent food and beverage
A medical center needs to install a display for diagnostic imagery, the space should be
designed according to which viewing category. Passive Viewing Full Motion Video Basic Decision
Making Analytical Decision Making
A field service technician replaces a piece of AV equipment on the client LAN but notices it's
not getting proper IP address. What's the most likely issue? The new piece of equipment needs
to have its MAC registered. The new piece of equipment has a defective USB port. The new
piece of equipment needs HDCP turned on. The new piece of equipment has different
firmware.
An installed audio system should be AT LEAST __________ above the ambient noise floor. 5
dB 25 dB 45 dB 75 dB
