ASE Auto Maintenance & Light
Repair Test (Test G1)
Comprehensive Questions
(Frequently Most Tested) with
Verified Answers
A tight timing belt makes what type of noise? - Answer: Whining
A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on
the odometer. The MOST likely cause for the leakage is: - Answer: plugged transmission breather filter
Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before
clamping the boot? - Answer: Burping
Steering dampers can be used to reduce excessive __________. - Answer: positive caster
A technician is rotating the tires using the modified X-method of tire rotation on a front-wheel-drive
vehicle. Where should be the right front wheel placed? - Answer: Right rear
The open circuit voltage (OCV) test on a fully charged battery should show which voltage? - Answer: 12.6
There is white exhaust smoke coming from the tailpipe of a vehicle well after the engine has been
started. What is causing this condition? - Answer: coolant in combustion chamber
A front wheel drive vehicle has a clacking noise that only occurs while cornering. The technician suspects
a faulty front axle. Which of these is most likely the cause? - Answer: outer CV Joint
The tread of a tire is worn in the center and not on the outer shoulders. Technician A says this is caused
by an improper wheel alignment angle. Technician B says this is caused by an over-inflated tire. Who is
correct? (Just the letter) - Answer: B
Repair Test (Test G1)
Comprehensive Questions
(Frequently Most Tested) with
Verified Answers
A tight timing belt makes what type of noise? - Answer: Whining
A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on
the odometer. The MOST likely cause for the leakage is: - Answer: plugged transmission breather filter
Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before
clamping the boot? - Answer: Burping
Steering dampers can be used to reduce excessive __________. - Answer: positive caster
A technician is rotating the tires using the modified X-method of tire rotation on a front-wheel-drive
vehicle. Where should be the right front wheel placed? - Answer: Right rear
The open circuit voltage (OCV) test on a fully charged battery should show which voltage? - Answer: 12.6
There is white exhaust smoke coming from the tailpipe of a vehicle well after the engine has been
started. What is causing this condition? - Answer: coolant in combustion chamber
A front wheel drive vehicle has a clacking noise that only occurs while cornering. The technician suspects
a faulty front axle. Which of these is most likely the cause? - Answer: outer CV Joint
The tread of a tire is worn in the center and not on the outer shoulders. Technician A says this is caused
by an improper wheel alignment angle. Technician B says this is caused by an over-inflated tire. Who is
correct? (Just the letter) - Answer: B
