Elevator Mechanic Exam Review
2025 update|comprehensive
questions and verified answers
(complete solutions) GRADE A+!!
Save
Terms in this set (216)
A contractor Diam=12" 12/4=3" 25fpm=3" 100fpm +
wants to raise 25fpm= 12"+3"= 15" sheave
the car speed
from 100fpm to
125fpm, it
currently has a
12" sheave. What
sheave is
required?
,A MOV (Metal Replace it with a larger MOV
Oxide Varistor)
burns out. You
replace it, but
cannot read
voltage or
resistance. What
should you do?
On a Ward- Suicide Circuit
Leonard circuit
the break is set,
but the motor is
trying to slip
through the
break. What is
the issue?
You have an old Leave the interpoles alone. When
DC motor and adding a SCR drive to the
are adding an generator, the series loop is
SCR drive, what removed, as are the 3 resistors.
do you do to Everything else remains the same
the interpoles?
, A hydro runs up The relief valve is set too low
with no load,
but will not run
with a full load.
What is the
issue?
Runby for a 1:1 22"
hits the CWT
buffer 4" below
the top landing.
CWT runby
should be set at
18". How much
should the
ropes be
shortened?
2025 update|comprehensive
questions and verified answers
(complete solutions) GRADE A+!!
Save
Terms in this set (216)
A contractor Diam=12" 12/4=3" 25fpm=3" 100fpm +
wants to raise 25fpm= 12"+3"= 15" sheave
the car speed
from 100fpm to
125fpm, it
currently has a
12" sheave. What
sheave is
required?
,A MOV (Metal Replace it with a larger MOV
Oxide Varistor)
burns out. You
replace it, but
cannot read
voltage or
resistance. What
should you do?
On a Ward- Suicide Circuit
Leonard circuit
the break is set,
but the motor is
trying to slip
through the
break. What is
the issue?
You have an old Leave the interpoles alone. When
DC motor and adding a SCR drive to the
are adding an generator, the series loop is
SCR drive, what removed, as are the 3 resistors.
do you do to Everything else remains the same
the interpoles?
, A hydro runs up The relief valve is set too low
with no load,
but will not run
with a full load.
What is the
issue?
Runby for a 1:1 22"
hits the CWT
buffer 4" below
the top landing.
CWT runby
should be set at
18". How much
should the
ropes be
shortened?
