Ironworker Final
The area on the wall where a door can be placed is more properly known as the - Answer-doorway
the purpose of a door closer is to - Answer-control the speed at which the door opens and closes
How does a door help to control the physical atmosphere of a space - Answer-By enclosing an area so
that the interior may be more effectively heated or cooled
The most common doors installed by Ironworkers are _____________. - Answer-Both A and B
The door swing, or handing, is always determined from the _________________. - Answer-Side of the
door you used the key on
If the hinges are on the left and door opens in its a - Answer-left hand door
if the hinges are on the right and the door opens out its a - Answer-right hand reverse door
An exterior sliding door usually has ______________ - Answer-a movable and a fixed panel
A revolving door consists of three or four doors called ________________. - Answer-leaves
,A _____________ keeps people from spinning a revolving door too fast. - Answer-governor
Service doors roll upward and are stored ____________. - Answer-on a coil above the opening
Modular reinforced panels used in modern bank vaults are made using a special blend of
________________. - Answer-concrete and additivies
The first step in installing a modern bank vault is to ________________. - Answer-Become familiar with
the manufactures drawings and instructions
Which of the following is a common type of hangar door that Ironworkers install? - Answer-Vertical lift
Which of the following is a type of hangar door most likely to be used with smaller hangars and
buildings? - Answer-Bi-fold
Which of the following types of hangar doors provides a canopy when the doors is in the open position -
Answer-Single panel
Which of the following types of hangar doors is most likely to be used when a large or even super-wide
door is needed? - Answer-Rolling
Which of the following types of hangar doors includes intermediate, horizontal aluminum sections fitted
between fabrics? - Answer-Vertical lift
Thin vault panels made from new materials available today are far stronger than the thicker poured
concrete walls. True /False - Answer-True
The skills needed to install hangar doors are significantly different from the skills required to install the
swing, sliding and revolving doors. True/False - Answer-False
, For Ironworkers, the term " layout " includes establishing control lines and benchmarks. TRUE OR False -
Answer-True
Surveying uses the techniques of ______________. - Answer-geometry and trigonometry
Historically, distances were measured ____________ - Answer-Through the use of chains with links
known as length
The ancient use of a compass to measure horizontal angles has not been improved upon. TRUE or False -
Answer-False
Early surveyors learned that the simplest method to measure height was with an altimeter. The
altimeter they used was basically a ______________. - Answer-barometer
Theodolites have been used to measure angles since ___________. - Answer-1571
A transit is a type of ______________. - Answer-theodolite
Distance is defined as the amount of _________ between two things - Answer-space
A horizontal measure is referred to as length or _______ - Answer-width
The term level means having a flat or even surface with no part higher than another. TRUE/FALSE -
Answer-True
Although some drawings refer to sea level, it is usually changed to ____________ - Answer-an elevation
above finished floor
The area on the wall where a door can be placed is more properly known as the - Answer-doorway
the purpose of a door closer is to - Answer-control the speed at which the door opens and closes
How does a door help to control the physical atmosphere of a space - Answer-By enclosing an area so
that the interior may be more effectively heated or cooled
The most common doors installed by Ironworkers are _____________. - Answer-Both A and B
The door swing, or handing, is always determined from the _________________. - Answer-Side of the
door you used the key on
If the hinges are on the left and door opens in its a - Answer-left hand door
if the hinges are on the right and the door opens out its a - Answer-right hand reverse door
An exterior sliding door usually has ______________ - Answer-a movable and a fixed panel
A revolving door consists of three or four doors called ________________. - Answer-leaves
,A _____________ keeps people from spinning a revolving door too fast. - Answer-governor
Service doors roll upward and are stored ____________. - Answer-on a coil above the opening
Modular reinforced panels used in modern bank vaults are made using a special blend of
________________. - Answer-concrete and additivies
The first step in installing a modern bank vault is to ________________. - Answer-Become familiar with
the manufactures drawings and instructions
Which of the following is a common type of hangar door that Ironworkers install? - Answer-Vertical lift
Which of the following is a type of hangar door most likely to be used with smaller hangars and
buildings? - Answer-Bi-fold
Which of the following types of hangar doors provides a canopy when the doors is in the open position -
Answer-Single panel
Which of the following types of hangar doors is most likely to be used when a large or even super-wide
door is needed? - Answer-Rolling
Which of the following types of hangar doors includes intermediate, horizontal aluminum sections fitted
between fabrics? - Answer-Vertical lift
Thin vault panels made from new materials available today are far stronger than the thicker poured
concrete walls. True /False - Answer-True
The skills needed to install hangar doors are significantly different from the skills required to install the
swing, sliding and revolving doors. True/False - Answer-False
, For Ironworkers, the term " layout " includes establishing control lines and benchmarks. TRUE OR False -
Answer-True
Surveying uses the techniques of ______________. - Answer-geometry and trigonometry
Historically, distances were measured ____________ - Answer-Through the use of chains with links
known as length
The ancient use of a compass to measure horizontal angles has not been improved upon. TRUE or False -
Answer-False
Early surveyors learned that the simplest method to measure height was with an altimeter. The
altimeter they used was basically a ______________. - Answer-barometer
Theodolites have been used to measure angles since ___________. - Answer-1571
A transit is a type of ______________. - Answer-theodolite
Distance is defined as the amount of _________ between two things - Answer-space
A horizontal measure is referred to as length or _______ - Answer-width
The term level means having a flat or even surface with no part higher than another. TRUE/FALSE -
Answer-True
Although some drawings refer to sea level, it is usually changed to ____________ - Answer-an elevation
above finished floor
