INDUSTRIAL ELECTRICIAN V5 (NCCER
EXAM) EXAM WITH CORRECT QUESTIONS
AND CORRECTRY ANALYZED ANSWERS
(ACTUAL EXAM) ALREADY GRADED A+
LATEST 2025 – 2026
What is shown on a sectional drawing? - ANSWERS-Cutaway view of a building
Eight incandescent lighting fixtures are to be installed. Each fixture is 120 volts,
with a 200-watt lamp. What is the total connected load? - ANSWERS-13.3 amps
An insulation resistance tester is also known as a(n) - ANSWERS-Megohmeter
, Which of the following is the classified location where combustible dust may be
present? - ANSWERS-Class I Div I
Any person who works in an electrical environment should NEVER wear jewelry or
clothing made of - ANSWERS-Polyester
On a push button, normally closed contacts are generally used to open a circuit to
- ANSWERS-Initiate a start or on circuit function
As the load decreases on a squirrel cage induction motor, its power factor -
ANSWERS-Decreases
THWN conductors have an outer jacket made of: - ANSWERS-Nylon
Which of the following is the classified location where combustible vapors are
always present? - ANSWERS-Class I Div I
When installing more than one ground rod, what is the MINIMUM spacing
between rods - ANSWERS-10 ft.
The length of bare copper conductor in a ground ring MUST be buried no less
than 2.5' below grade and - ANSWERS-10 ft.
EXAM) EXAM WITH CORRECT QUESTIONS
AND CORRECTRY ANALYZED ANSWERS
(ACTUAL EXAM) ALREADY GRADED A+
LATEST 2025 – 2026
What is shown on a sectional drawing? - ANSWERS-Cutaway view of a building
Eight incandescent lighting fixtures are to be installed. Each fixture is 120 volts,
with a 200-watt lamp. What is the total connected load? - ANSWERS-13.3 amps
An insulation resistance tester is also known as a(n) - ANSWERS-Megohmeter
, Which of the following is the classified location where combustible dust may be
present? - ANSWERS-Class I Div I
Any person who works in an electrical environment should NEVER wear jewelry or
clothing made of - ANSWERS-Polyester
On a push button, normally closed contacts are generally used to open a circuit to
- ANSWERS-Initiate a start or on circuit function
As the load decreases on a squirrel cage induction motor, its power factor -
ANSWERS-Decreases
THWN conductors have an outer jacket made of: - ANSWERS-Nylon
Which of the following is the classified location where combustible vapors are
always present? - ANSWERS-Class I Div I
When installing more than one ground rod, what is the MINIMUM spacing
between rods - ANSWERS-10 ft.
The length of bare copper conductor in a ground ring MUST be buried no less
than 2.5' below grade and - ANSWERS-10 ft.
