100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.6 TrustPilot
logo-home
Exam (elaborations)

RCDD 12th Edition Chapter 5 Exam 2025 Questions and Answers 100% Pass

Rating
-
Sold
-
Pages
10
Grade
A+
Uploaded on
25-04-2025
Written in
2024/2025

RCDD 12th Edition Chapter 5 Exam 2025 Questions and Answers 100% Pass Horizontal pathways include = - - Continuous pathways used for containment of telecomm cabling - Non-continuous pathways (J-hooks) Pull boxes or splice boxes = - Considered spaces not pathways Wet location = - Soil, sand and gravel Horizontal pathways include = - - Underfloor ducts - Cellular floors - Conduits - Cable trays - Access floors - Ceiling distribution - Surface-mounted raceways Usable floor space = - Hallways BAS = - [250ft] squared floor space Pathway capacity for BAS = - One cable for each system or coverage area. WA = - [100ft] squared BAS floor outlet for = - Every [250ft] 2COPYRIGHT © 2025 BY EMILLY CHARLOTTE, ALL RIGHTS RESERVED Copper 4-pair 100 ohm = - [0.35in] Fiber Optical cable = - [0.18in] During cable pulling, flexible conduit tends to = - - Creep - Shift - Cause sheath damage to the cable If flexible conduit is to be used = - Size should be increased by one trade size relative to the size of a rigid conduit. Flexible conduit = - Not recommended ITS designer should design and install conduits to = - - Achieve the best direct route with no single bend greater than 90 degrees or an aggregate of bends in access of 180 degrees between pull point boxes - Contain no continuous sections sections longer than 30m(100ft) - Bonded and grounded at each end in accordance with national or local code requirements - Withstand the environment to which they will be exposed Conduit runs 30m [100ft] = - Pull points or pull boxes should be inserted that segment between points/boxes exceeds the 30m [100ft] length Conduit should not be run = - - On top of cellular floors cell - Crosswise to cellular floor - Through areas in which flammable material maybe stored Over or adjacent to heat sources such as = - Never place conduit Aluminum or electrical nonmetallic tubing (ENT) thin walle

Show more Read less
Institution
RCDD
Course
RCDD









Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
RCDD
Course
RCDD

Document information

Uploaded on
April 25, 2025
Number of pages
10
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

RCDD 12th Edition Chapter 5 Exam
2025 Questions and Answers 100% Pass


Horizontal pathways include = - ✔✔- Continuous pathways used for containment of
telecomm cabling

- Non-continuous pathways (J-hooks)

Pull boxes or splice boxes = - ✔✔Considered spaces not pathways

Wet location = - ✔✔Soil, sand and gravel

Horizontal pathways include = - ✔✔- Underfloor ducts

- Cellular floors

- Conduits

- Cable trays

- Access floors

- Ceiling distribution

- Surface-mounted raceways

Usable floor space = - ✔✔Hallways

BAS = - ✔✔[250ft] squared floor space

Pathway capacity for BAS = - ✔✔One cable for each system or coverage area.

WA = - ✔✔[100ft] squared

BAS floor outlet for = - ✔✔Every [250ft]



COPYRIGHT © 2025 BY EMILLY CHARLOTTE, ALL RIGHTS RESERVED 1

, Copper 4-pair 100 ohm = - ✔✔[0.35in]

Fiber Optical cable = - ✔✔[0.18in]

During cable pulling, flexible conduit tends to = - ✔✔- Creep

- Shift

- Cause sheath damage to the cable

If flexible conduit is to be used = - ✔✔Size should be increased by one trade size
relative to the size of a rigid conduit.

Flexible conduit = - ✔✔Not recommended

ITS designer should design and install conduits to = - ✔✔- Achieve the best direct
route with no single bend greater than 90 degrees or an aggregate of bends in access
of 180 degrees between pull point boxes

- Contain no continuous sections sections longer than 30m(100ft)

- Bonded and grounded at each end in accordance with national or local code
requirements

- Withstand the environment to which they will be exposed

Conduit runs 30m [100ft] = - ✔✔Pull points or pull boxes should be inserted that
segment between points/boxes exceeds the 30m [100ft] length

Conduit should not be run = - ✔✔- On top of cellular floors cell

- Crosswise to cellular floor

- Through areas in which flammable material maybe stored

Over or adjacent to heat sources such as = - ✔✔Never place conduit

Aluminum or electrical nonmetallic tubing (ENT) thin walled plastic conduit = -
✔✔Never to be placed in concrete floors

Cable pull force is determined by several factors = - ✔✔- Cable type



COPYRIGHT © 2025 BY EMILLY CHARLOTTE, ALL RIGHTS RESERVED 2

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
EmillyCharlotte Howard Community College
View profile
Follow You need to be logged in order to follow users or courses
Sold
98
Member since
1 year
Number of followers
5
Documents
11964
Last sold
2 weeks ago
ALL-MAJOR.

On this page, you find all documents, package deals, and flashcards offered by seller Emilly Charlotte.

3.5

21 reviews

5
7
4
6
3
2
2
3
1
3

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions