A roof is 80' x 64' and one pallet has 6.45 squares of material. How many pallets are needed? - Answers
8 pallets
The size of a house with a flat roof is 25' x 28'. It has a garage with a flat roof of 15' x 18'. How much
roofing do the both of them need? - Answers 10 squares
A roof is 30' x 40'. If you need 1 square for the starter, 1 square for waste, and 1 2/3 square for hip and
ridge, how much roofing material will you need? - Answers 16 squares
Given that a sloped roof has an area of 1,160 sq ft. How many rolls of 15 pound felt (4 sq/roll) are
needed to cover the roof with one layer? - Answers 3
Which statement is most correct? - Answers Tar is distilled from soft coal
Given a scale 1/4" = 1' what is 3'-6" - Answers 7/8"
Which of the following is the correct order for installing a tile roof? - Answers Lay underlayment; snap
chalkline; load tile; install tile
What is the purpose of a shake liner? - Answers To waterproof the roof
Which of the following are you most likely to use when nailing composition roof shingles on a felted
plywood deck? - Answers Coil nail gun
Which of the following types of insulation cannot be used in direct contact with BUR? - Answers
Polystyrene board
How should you walk on a roof with flat concrete tiles? - Answers Step of the headlap of the tiles
How would you load tile onto a roof? - Answers Load 6 tiles high and 3 ft from the edge
The chalk line for installing tile should be set - Answers Perpendicular to the eave
In a moderate climate with a normal slope, how far should back flashing go upside off a chimney? -
Answers 18"
Why should you not install composition single roofs when the temperature is 40* F or below? - Answers
The shingles can crack too easily with handling and nailing
What in the best way to prevent a leak behind a 36" wide masonry chimney? - Answers Install a cricket
What is the best way to walk on spaced seating? - Answers Step on the 1" x 4" and on the rafters
Composition flashing (base flashing) should be fastened with? - Answers One inch solid cap-head nails or
nails driven through tin disks