SHP final Exam Questions and Answers Latest Update 2025

SHP final Exam Questions and Answers Latest Update 2025 True - Answers The firefighter may be installed next to a stand-alone battery smoke detector False - Answers When performing a full system test, you may bypass any open doors or windows Always enable the emergency - Answers When programming an skey1,you must False - Answers When running power to the take345,polarity doesn't apply Audible alarm (7) - Answers When programming the emergency key for the skey1,which zone/sensor type is used. True - Answers When installing a smkt3,you must use the included screws and anchors True - Answers When installing the firefighter, it is required to test the customers existing smoke detectors Between 6"(15cm) and 2'(61cm) from floor - Answers When installing a Dw21, where is the approved location for the sensor Provided double sided tape - Answers When installing a dw11 on a vinyl or metal frame, what should primarily use to mount the sensor Beans & wire caps - Answers Which of the following materials can you use to group multiple ground terminals in a takeover. Smoke detector - Answers Which of the following sensors are you not allowed to program using a translator True - Answers When installing the take345, you must always test the new 12v battery before using it. 16.5 - Answers What is the output voltage of transformer used to power the sky control 12" - Answers What is the minimum distance for placement of a co3 from the corners of the wall False - Answers The smkt3 has 2 function:smoke and heat detection Loop 1 Zone 14 - Answers How would you program a co3 if mounted on a hallway wall False - Answers When installing a translator, you must program all of the existing sensors as new equipment on the panel True - Answers The dw21 should always be installed in the door frame (09) Smoke detector. (09) Heat detector. (08) Freeze - Answers Which of the following zone/sensor types are correct when programming an smkt3 7ft - Answers What it the correct height ar which to install the Pir2 Loop 2 - Answers When programming a Dw21 what loop number is used True - Answers When programming a sensor into a sky control panel, you can type in the serial number or learn it in by triggering the device. Loop 1 Zone 3 - Answers How would you program a gb2 when it is mounted on a master bedroom ceiling True - Answers Panic pendants are programmed as an audible alarm(type 07) True - Answers When installing the take 345 you must ensure that the transformer is supplying power to the power supply before connecting the battery True - Answers When wiring the take 345 you must ensure it has three points of ground: the low side of each zone, the takeover module, and the power supply True - Answers You are required to test all secondary keypads and key fobs even though they are not detection devices 3/4" - Answers When installing a dw21, what size drill bit should you use to drill the hole for the sensor Loop 1 - Answers When programming a Pir2, which loop number must you use