INTRODUCTION TO NETWORK
SIMULATIONS WITH CISCO
MODELING LABS REVIEW
QUESTIONS WITH VERIFIED
SOLUTIONS RATED A+
Controller - CORRECT-ANSWER-Component responsible for deploying
virtual devices and providing details about running labs.
Node and Image Definitions interface - CORRECT-ANSWER-The
interface available from the Tools button that provides details on all the
images currently available on a Cisco Modeling Labs installation.
REST - CORRECT-ANSWER-The type of API that Cisco Modeling Labs is
built on.
, Berkeley Packet Filter (BPF) - CORRECT-ANSWER-Type of filter used to
restrict the packets captured on a link in Cisco Modeling Labs.
NAT mode - CORRECT-ANSWER-Mode used to configure an external
connector that was being used to provide inbound management
connectivity to simulated hosts.
External connector connections - CORRECT-ANSWER-1.
TRex - CORRECT-ANSWER-Node type that can be used to generate
traffic within a network simulation.
Dynamic Layer 3 addresses - CORRECT-ANSWER-Cisco Modeling Labs
does NOT know the dynamic Layer 3 addresses assigned to nodes from
a DHCP server accessed through a bridge external connection.
SIMULATIONS WITH CISCO
MODELING LABS REVIEW
QUESTIONS WITH VERIFIED
SOLUTIONS RATED A+
Controller - CORRECT-ANSWER-Component responsible for deploying
virtual devices and providing details about running labs.
Node and Image Definitions interface - CORRECT-ANSWER-The
interface available from the Tools button that provides details on all the
images currently available on a Cisco Modeling Labs installation.
REST - CORRECT-ANSWER-The type of API that Cisco Modeling Labs is
built on.
, Berkeley Packet Filter (BPF) - CORRECT-ANSWER-Type of filter used to
restrict the packets captured on a link in Cisco Modeling Labs.
NAT mode - CORRECT-ANSWER-Mode used to configure an external
connector that was being used to provide inbound management
connectivity to simulated hosts.
External connector connections - CORRECT-ANSWER-1.
TRex - CORRECT-ANSWER-Node type that can be used to generate
traffic within a network simulation.
Dynamic Layer 3 addresses - CORRECT-ANSWER-Cisco Modeling Labs
does NOT know the dynamic Layer 3 addresses assigned to nodes from
a DHCP server accessed through a bridge external connection.