A vehicle has a low spongy brake pedal. Which of these is LEAST likely to result in this
condition?
A. Loose wheel bearings.
B. Contaminated brake fluid.
C. Worn brake pads.
D. Air in the hydraulic system.
Give this one a try later!
, Answer C is correct. Low brake pads would result in a warning clip squeal
or tire pad sensor light illumination.
A vehicle pulls to the left only when the brakes are applied. This condition is MOST
likely caused by:
A. A seized left front caliper.
B. A restriction in the left front brake line.
C. Leaking master cylinder cup seals.
D. A seized right front caliper.
Give this one a try later!
Answer D is correct. A frozen right front caliper will cause the vehicle to
pull to the left when braking.
A technician is measuring the inside diameter of a brake drum with a brake drum
micrometer. The technician should use which of the following measurements
A. The smallest measurement.
B. A brake drum tool is not used.
C. The average of all the measurements.
D. The largest measurement.
Give this one a try later!
Answer D is correct. The largest measurement is used.
Which of these is not part of an integral ABS unit.
A. Hydraulic Booster
condition?
A. Loose wheel bearings.
B. Contaminated brake fluid.
C. Worn brake pads.
D. Air in the hydraulic system.
Give this one a try later!
, Answer C is correct. Low brake pads would result in a warning clip squeal
or tire pad sensor light illumination.
A vehicle pulls to the left only when the brakes are applied. This condition is MOST
likely caused by:
A. A seized left front caliper.
B. A restriction in the left front brake line.
C. Leaking master cylinder cup seals.
D. A seized right front caliper.
Give this one a try later!
Answer D is correct. A frozen right front caliper will cause the vehicle to
pull to the left when braking.
A technician is measuring the inside diameter of a brake drum with a brake drum
micrometer. The technician should use which of the following measurements
A. The smallest measurement.
B. A brake drum tool is not used.
C. The average of all the measurements.
D. The largest measurement.
Give this one a try later!
Answer D is correct. The largest measurement is used.
Which of these is not part of an integral ABS unit.
A. Hydraulic Booster
