Page | 1
PA APPRAISERS LICENSE 2025| BRAND NEW ACTUAL
EXAM WITH 100% VERIFIED QUESTIONS AND CORRECT
SOLUTIONS| GUARANTEED VALUE PACK| ACE YOUR
GRADES.
How is a diamond condition fixed? - correct answer - By pulling
the damage for length. Diamond is a length condition.
When measuring a unibody vehicle, it is discovered that the left
front rail is 111mm from spec in width. What condition is this? -
correct answer - Width is calculated from the center out, so a
value of -111mm on the left rail shows sway to the right and in
toward centerline.
A collision damaged vehicle is discovered to be down in height at
opposite end of the center section. - correct answer - Twist
condition.
When diagnosing the damage to a full frame assembly on a sport
utility vehicle, it is determined that the left side frame rail is higher
than the right side frame rail. Technician A says the damaged
state is known as a twist condition. Technician B says a sway
condition exists. Who is right? - correct answer - Tech A. When a
, Page | 2
frame rail's relationship to the vehicle centerline is changed, such
as pushed either to the left or right, the condition is known as
sway. "Twist" is referred as the condition of the frame when entire
sections are driven higher or lower than the opposite side.
Metal fillers contain different ingredients that provide fillers with
special properties. - correct answer - Fiberglass offers more
resistance to moisture
HSLA - correct answer - High Strength Low Alloy
When replacing the floor pan in the trunk area, what joint should
be used to join the new pan to the existing floor? - correct answer
- An overlap joint
When acoustical foam is removed during the repair: - correct
answer - It must be replaced with acoustical foam.
When setting up a three-dimensional measuring system, it should
be setup on an undamaged area. - correct answer - Starting in the
center section is the correct method.
, Page | 3
What is the plastic Black box in rear of the car? - correct answer -
Vapor Canister
Grinding or squeaking from wheel is a sign of what? - correct
answer - Bad Bearings
The insurance commissioner is responsible for everything
except? - correct answer - Endorsing an insurance company
How do you tell when a ball joint is bad? - correct answer -
Measure fixed points from knuckle to rotor
What makes the windows go up and down? - correct answer -
Window regulator
What panel needs to get removed is there is damage to the
quarter panel? - correct answer - The taillight
, Page | 4
Actuator - correct answer - Tells something to do something
Sensor - correct answer - Take reading and tell when something
is wrong
What is Urethane Paint? - correct answer - Better than acrylic,
extremely durable, and resists chipping; easier to apply
What makes up the body of the vehicle? - correct answer -
Anything that is welded together
Who has the first right to salvage? - correct answer - The insurer
What components make up a unibody? - correct answer - Last
answer, longest answer on exam question
PA APPRAISERS LICENSE 2025| BRAND NEW ACTUAL
EXAM WITH 100% VERIFIED QUESTIONS AND CORRECT
SOLUTIONS| GUARANTEED VALUE PACK| ACE YOUR
GRADES.
How is a diamond condition fixed? - correct answer - By pulling
the damage for length. Diamond is a length condition.
When measuring a unibody vehicle, it is discovered that the left
front rail is 111mm from spec in width. What condition is this? -
correct answer - Width is calculated from the center out, so a
value of -111mm on the left rail shows sway to the right and in
toward centerline.
A collision damaged vehicle is discovered to be down in height at
opposite end of the center section. - correct answer - Twist
condition.
When diagnosing the damage to a full frame assembly on a sport
utility vehicle, it is determined that the left side frame rail is higher
than the right side frame rail. Technician A says the damaged
state is known as a twist condition. Technician B says a sway
condition exists. Who is right? - correct answer - Tech A. When a
, Page | 2
frame rail's relationship to the vehicle centerline is changed, such
as pushed either to the left or right, the condition is known as
sway. "Twist" is referred as the condition of the frame when entire
sections are driven higher or lower than the opposite side.
Metal fillers contain different ingredients that provide fillers with
special properties. - correct answer - Fiberglass offers more
resistance to moisture
HSLA - correct answer - High Strength Low Alloy
When replacing the floor pan in the trunk area, what joint should
be used to join the new pan to the existing floor? - correct answer
- An overlap joint
When acoustical foam is removed during the repair: - correct
answer - It must be replaced with acoustical foam.
When setting up a three-dimensional measuring system, it should
be setup on an undamaged area. - correct answer - Starting in the
center section is the correct method.
, Page | 3
What is the plastic Black box in rear of the car? - correct answer -
Vapor Canister
Grinding or squeaking from wheel is a sign of what? - correct
answer - Bad Bearings
The insurance commissioner is responsible for everything
except? - correct answer - Endorsing an insurance company
How do you tell when a ball joint is bad? - correct answer -
Measure fixed points from knuckle to rotor
What makes the windows go up and down? - correct answer -
Window regulator
What panel needs to get removed is there is damage to the
quarter panel? - correct answer - The taillight
, Page | 4
Actuator - correct answer - Tells something to do something
Sensor - correct answer - Take reading and tell when something
is wrong
What is Urethane Paint? - correct answer - Better than acrylic,
extremely durable, and resists chipping; easier to apply
What makes up the body of the vehicle? - correct answer -
Anything that is welded together
Who has the first right to salvage? - correct answer - The insurer
What components make up a unibody? - correct answer - Last
answer, longest answer on exam question
