PA APPRAISERS LICENSE EXAM
QUESTIONS AND CORRECT VERIFIED
ANSWERS ALREADY A+ GRADED
WITH EXPERT FEEDBACK LATEST
VERSION|NEW|REVISED
Save
Terms in this set (347)
How is a diamond By pulling the damage for length.
condition fixed? Diamond is a length condition.
When measuring a Width is calculated from the center out,
unibody vehicle, it so a value of -111mm on the left rail
is discovered that shows sway to the right and in toward
the left front rail is centerline.
111mm from spec in
width. What
condition is this?
,A collision Twist condition.
damaged vehicle
is discovered to
be down in height
at opposite end of
the center section.
When diagnosing Tech A. When a frame rail's relationship
the damage to a to the vehicle centerline is changed,
full frame such as pushed either to the left or
assembly on a right, the condition is known as sway.
sport utility "Twist" is referred as the condition of
vehicle, it is the frame when entire sections are
determined that driven higher or lower than the
the left side frame opposite side.
rail is higher than
the right side
frame rail.
Technician A says
the damaged state
is known as a twist
condition.
Technician B says a
sway condition
exists. Who is
right?
, Metal fillers Fiberglass offers more resistance to
contain different moisture
ingredients that
provide fillers with
special properties.
HSLA High Strength Low Alloy
When replacing An overlap joint
the floor pan in
the trunk area,
what joint should
be used to join the
new pan to the
existing floor?
When acoustical It must be replaced with acoustical
foam is removed foam.
during the repair:
When setting up a Starting in the center section is the
three-dimensional correct method.
measuring system,
it should be setup
on an undamaged
area.
What is the plastic Vapor Canister
Black box in rear
of the car?
QUESTIONS AND CORRECT VERIFIED
ANSWERS ALREADY A+ GRADED
WITH EXPERT FEEDBACK LATEST
VERSION|NEW|REVISED
Save
Terms in this set (347)
How is a diamond By pulling the damage for length.
condition fixed? Diamond is a length condition.
When measuring a Width is calculated from the center out,
unibody vehicle, it so a value of -111mm on the left rail
is discovered that shows sway to the right and in toward
the left front rail is centerline.
111mm from spec in
width. What
condition is this?
,A collision Twist condition.
damaged vehicle
is discovered to
be down in height
at opposite end of
the center section.
When diagnosing Tech A. When a frame rail's relationship
the damage to a to the vehicle centerline is changed,
full frame such as pushed either to the left or
assembly on a right, the condition is known as sway.
sport utility "Twist" is referred as the condition of
vehicle, it is the frame when entire sections are
determined that driven higher or lower than the
the left side frame opposite side.
rail is higher than
the right side
frame rail.
Technician A says
the damaged state
is known as a twist
condition.
Technician B says a
sway condition
exists. Who is
right?
, Metal fillers Fiberglass offers more resistance to
contain different moisture
ingredients that
provide fillers with
special properties.
HSLA High Strength Low Alloy
When replacing An overlap joint
the floor pan in
the trunk area,
what joint should
be used to join the
new pan to the
existing floor?
When acoustical It must be replaced with acoustical
foam is removed foam.
during the repair:
When setting up a Starting in the center section is the
three-dimensional correct method.
measuring system,
it should be setup
on an undamaged
area.
What is the plastic Vapor Canister
Black box in rear
of the car?
