Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 3 out of 16 pages
Exam (elaborations)

Va Contractors License Exam Correctly Answered

Document preview thumbnail
Preview 3 out of 16 pages

What is the range of slump for concrete used in the wall? - 4 inches minimum 8 inches max What is the most common cause of injury on a construction site? - Falls In how many hours must a fatality be reported to OSHA? - Within 8 hours What is the maximum time between mixing and using water above 80°? - 2 1/2 hours What plan would show the building lot with boundaries? - Site plans What is the maximum riser height and minimum tread depth for stairway built in Virginia? - 8 1/4 inches and 9 inches How far must thermal insulation be kept from a recessed fixture enclosure? - 3 inches What is the minimum size and location of rebar in a footing supporting a slab? - Two #4 and within the middle third of the footing depth What is the required height of the top of a foundation above the elevation of the street gutter on a graded site? - 12 inches +2% What is the minimum distance from exposed ground for a wood framing member that is in contact with?? - 24 inches What is the maximum allowed slope for the top surface of a footing? - None Where should a drip edge be used? - Beneath the underlayment What is the minimum height for guard rails for balcony? - 36 inches What test is performed to determine the drainage capacity of a soil? - Perculation test- Perc Test

Content preview

Va Contractors License Exam Correctly
Answered

What is the range of slump for concrete used in the wall? - ✅✅ 4 inches
minimum 8 inches max


What is the most common cause of injury on a construction site? - ✅✅ Falls


In how many hours must a fatality be reported to OSHA? - ✅✅ Within 8 hours


What is the maximum time between mixing and using water above 80°? - ✅✅ 2
1/2 hours


What plan would show the building lot with boundaries? - ✅✅ Site plans


What is the maximum riser height and minimum tread depth for stairway built in
Virginia? - ✅✅ 8 1/4 inches and 9 inches


How far must thermal insulation be kept from a recessed fixture enclosure? -
✅✅ 3 inches


What is the minimum size and location of rebar in a footing supporting a slab? -
✅✅ Two #4 and within the middle third of the footing depth

,What is the required height of the top of a foundation above the elevation of the
street gutter on a graded site? - ✅✅ 12 inches +2%


What is the minimum distance from exposed ground for a wood framing member
that is in contact with?? - ✅✅ 24 inches


What is the maximum allowed slope for the top surface of a footing? - ✅✅ None


Where should a drip edge be used? - ✅✅ Beneath the underlayment


What is the minimum height for guard rails for balcony? - ✅✅ 36 inches


What test is performed to determine the drainage capacity of a soil? - ✅✅
Perculation test- Perc Test


What is the minimum width of footings used for a one story structure build on clay
sand soil used in conventional light frame construction? - ✅✅ 12 inches


What is the maximum allowable span for a three ply 2" x 12" build up floor girder
for an interior bearing wall in a one story frame home 28 feet wide? - ✅✅ 8 ft 10
inches


When a joist is notched at the bottom to bear on a ledger the notch in the joist
should be a maximum of? - ✅✅ 1/4 of the depth of the joist


When are roof drains required? - ✅✅ When the roof has parapet walls

, What are the actual measurements of a standard size modular concrete block? -
✅✅ 7 5/8 in height and 7 5/8 width times 15 5/8 length


In re-roofing applications metal flashing to which bituminous materials are to be
adhered shall be? - ✅✅ Primed


Soil that has expansion characteristics should? - ✅✅ Should not be used for
Backfill


Concrete cured with a proper moisture and a favorable temperature typically
achieves what percentage of specified compressive strength after 7 days? - ✅✅
60-75%


The minimum headroom for a stairway is measured vertically from the? - ✅✅
Sloped plane adjoining the tread nosing


What is the maximum spacing between studs of a 2 x 4 framed interior partition
supporting roof and ceiling only? - ✅✅ 24 inches


What is assumed to be the load bearing capacity of clay soil if no test are required
or made? - ✅✅ 1,500 pounds per square ft


Who is responsible for training employees about the hazards of working in
confined spaces? - ✅✅ Employer


What is the maximum on center spacing of vertical reinforcement for a 12 inch
nominal thickness reinforced concrete foundation wall? - ✅✅ 72 inches

Document information

Uploaded on
March 25, 2025
Number of pages
16
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$11.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
kharowl
3.0
(2)
Sold
14
Followers
7
Items
1509
Last sold
7 months ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions