A17 Telehandler Revision
When working in a confined area or space:
a) what danger can be present with regards to the counterweight of the machine,
b) when should measures be taken
and
c) what measures should be implemented? - Answer-a) the gap between the counterweight and a
structure being reduced or contacting structure/object when slewing.
b) when the gap will be less than 600mm.
c) ensure sufficient clearance or block off access routes
Apart from the operator, who else may need to use the machine's Operator's Manual? - Answer-
Supervisors, fitters, low loader drivers
Using the lifting capacity diagram for A17:
a) what is the maximum lifting capacity at maximum
height,
b) what is the lifting capacity with the boom angle at 45 degrees and a boom extension
of 2.5 metres and
, c) what is the farthest distance (measured from the front tyres) available to place a 1.3 tonnes load at a
height of 4 metres? - Answer-a) 3.3 tonnes or 3300 kilograms
b) 2.5 tonnes or 2500 kilograms
c) 5.3 metres
Name THREE ways that a plant operator can contribute in ensuring repeat business with the client or
principal contractor - Answer-1. Compliance with the method Statements.
2. Cooperation with the workforce.
3. Safe working practices.
4. Work Efficiently.
5. Punctuality
According to regulations (such as Lifting Operations and Lifting Equipment Regulations (LOLER) 1998)
name TWO requirements that must be carried out on any lifting operation. - Answer-Lifts must be
properly PLANNED and SUPERVISED
Name THREE ways in which an operator can minimise their impact upon the environment whilst using
the machine. - Answer-1. Lower engine speed,
2. correct disposal of waste,
3. follow method statements,
4. well maintained machine.
If a load is being lifted whilst the telehandler is on a slope and facing downhill, what effect could this
have on the machine? - Answer-Load centre/centre of gravity can increase causing instability
An operator has been asked to transport a load along the public highway from one site to another, for
which The Road Traffic Act applies. What needs to be taken into account regarding the law? - Answer-
Depending on vehicle classification, movement of loads is restricted to certain distances. (normally
maximum of 1000 yards)
When working in a confined area or space:
a) what danger can be present with regards to the counterweight of the machine,
b) when should measures be taken
and
c) what measures should be implemented? - Answer-a) the gap between the counterweight and a
structure being reduced or contacting structure/object when slewing.
b) when the gap will be less than 600mm.
c) ensure sufficient clearance or block off access routes
Apart from the operator, who else may need to use the machine's Operator's Manual? - Answer-
Supervisors, fitters, low loader drivers
Using the lifting capacity diagram for A17:
a) what is the maximum lifting capacity at maximum
height,
b) what is the lifting capacity with the boom angle at 45 degrees and a boom extension
of 2.5 metres and
, c) what is the farthest distance (measured from the front tyres) available to place a 1.3 tonnes load at a
height of 4 metres? - Answer-a) 3.3 tonnes or 3300 kilograms
b) 2.5 tonnes or 2500 kilograms
c) 5.3 metres
Name THREE ways that a plant operator can contribute in ensuring repeat business with the client or
principal contractor - Answer-1. Compliance with the method Statements.
2. Cooperation with the workforce.
3. Safe working practices.
4. Work Efficiently.
5. Punctuality
According to regulations (such as Lifting Operations and Lifting Equipment Regulations (LOLER) 1998)
name TWO requirements that must be carried out on any lifting operation. - Answer-Lifts must be
properly PLANNED and SUPERVISED
Name THREE ways in which an operator can minimise their impact upon the environment whilst using
the machine. - Answer-1. Lower engine speed,
2. correct disposal of waste,
3. follow method statements,
4. well maintained machine.
If a load is being lifted whilst the telehandler is on a slope and facing downhill, what effect could this
have on the machine? - Answer-Load centre/centre of gravity can increase causing instability
An operator has been asked to transport a load along the public highway from one site to another, for
which The Road Traffic Act applies. What needs to be taken into account regarding the law? - Answer-
Depending on vehicle classification, movement of loads is restricted to certain distances. (normally
maximum of 1000 yards)
