• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 2 out of 11 pages
Exam (elaborations)

NATE Heat Study Guide Exam.

Document preview thumbnail
Preview 2 out of 11 pages

NATE Heat Study Guide Exam. R-22 vapor line diameters and lengths are typically specified for a vapor pressure drop that does not exceed what value? - CORRECT ANSWER d. 6-7 psi or 6 degrees F Which of the following is a primary consideration when bending soft copper tubing into a bend of any radius? - CORRECT ANSWER the cross-sectional area of the tube must not be significantly reduced The water that results from a defrost cycle of an air to air heat pump (run off) must drain off and away from the outdoor coil. What can happen if the defrost runoff is not properly drained away? - CORRECT ANSWER excessive ice can build up on the bottom of the coil and reduce capacity The component used to reduce sound transmission and prevent water leaks of a packaged heat pump - CORRECT ANSWER curb gasket To more accurately sense the refrigerant temperature of horizontal suction lines that are 11/8" or larger, a thermostatic expansion valve sensing bulb should be mounted at which of the following positions? - CORRECT ANSWER 4 or 8 o'clock In order for an evacuation to be considered complete, a heat pump refrigerant circuit should be evacuated to a vacuum pressure of: - CORRECT ANSWER C. 500 microns When first inspecting a system known to be leaking, the technician should look for: - CORRECT ANSWER d. traces of oil Which of the following measurements are needed to determine low side superheat? - CORRECT ANSWER d. suction pressure and suction line pressure temperature Drive slips are typically installed where, on rectangular duct? - CORRECT ANSWER d. on the shorter sides To properly set a heat anticipator it is necessary to check the: - CORRECT ANSWER b. heating control circuit amperage draw Using a voltmeter, how does the technician determine voltage drop on the outdoor unit of a heat pump? - CORRECT ANSWER d. with the outdoor unit not operating and then with the outdoor unit operating. What is the smallest refrigerant leak that an electronic leak detector should be capable of sensing? - CORRECT ANSWER b. 5 oz per year When checking the pressures in an operating system with a manifold gauge set, refrigerant oil in a hose will - CORRECT ANSWER c. have no effect on the gauge reading Which of the following is used to measure air pressure? - CORRECT ANSWER d. diaphragm type differential pressure gauge A residential supply diffuser that is noisy because of a loose van is best serviced by: - CORRECT ANSWER d. replacing the diffuser

Content preview

NATE Heat Study Guide Exam.

R-22 vapor line diameters and lengths are typically specified for a vapor pressure drop that does not

exceed what value? - CORRECT ANSWER d. 6-7 psi or 6 degrees F



Which of the following is a primary consideration when bending soft copper tubing into a bend of any

radius? - CORRECT ANSWER the cross-sectional area of the tube must

not be significantly reduced



The water that results from a defrost cycle of an air to air heat pump (run off) must drain off and away

from the outdoor coil. What can happen if the defrost runoff is not properly drained away? - CORRECT
ANSWER excessive ice can build up on the bottom of the coil and reduce capacity



The component used to reduce sound transmission and prevent water leaks of a packaged heat pump -
CORRECT ANSWER curb gasket



To more accurately sense the refrigerant temperature of horizontal suction lines that are 11/8" or

larger, a thermostatic expansion valve sensing bulb should be mounted at which of the following
positions? - CORRECT ANSWER 4 or 8 o'clock



In order for an evacuation to be considered complete, a heat pump refrigerant circuit should be
evacuated to a vacuum pressure of: - CORRECT ANSWER C. 500 microns



When first inspecting a system known to be leaking, the technician should look for: - CORRECT ANSWER
d. traces of oil



Which of the following measurements are needed to determine low side superheat? - CORRECT
ANSWER d. suction pressure and suction line pressure temperature

, Drive slips are typically installed where, on rectangular duct? - CORRECT ANSWER d. on the shorter
sides



To properly set a heat anticipator it is necessary to check the: - CORRECT ANSWER b. heating control
circuit amperage draw



Using a voltmeter, how does the technician determine voltage drop on the outdoor unit of a heat
pump? - CORRECT ANSWER d. with the outdoor unit not operating and

then with the outdoor unit operating.



What is the smallest refrigerant leak that an electronic leak detector should be capable of sensing? -
CORRECT ANSWER b. 5 oz per year



When checking the pressures in an operating system with a manifold gauge set, refrigerant oil in a hose
will - CORRECT ANSWER c. have no effect on the gauge reading



Which of the following is used to measure air pressure? - CORRECT ANSWER d. diaphragm type
differential pressure

gauge



A residential supply diffuser that is noisy because of a loose van is best serviced by: - CORRECT ANSWER
d. replacing the diffuser



When performing preventive maintenance on a heat pump the technician should check the outdoor fan

to be certain - CORRECT ANSWER c: the fan runs freely with no binding



What is the effect of 170 volts supplied to a 208/230 volt compressor? - CORRECT ANSWER c. current
increases and the motor may trip



On a service call for a cooling problem with a heat pump, your inspections find a liquid line that has

condensation on it. What is the most likely cause? - CORRECT ANSWER b. liquid line is restricted

Document information

Uploaded on
March 16, 2025
Number of pages
11
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$12.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
ROSEGRADES
3.4
(35)
Sold
236
Followers
87
Items
12121
Last sold
1 month ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions