General Contractor Trade Exam Questions and Answers 100% Pass

General Contractor Trade Exam Questions and Answers 100% Pass brick on a job site should be covered - when you leave at the end of the day how long should tile set on a organic adhesive bed in order to cure - 24 hours what is the correct space (gap) between a finished floor and bottom of an interior door with no threshold - 1/2" what are as built plans - plans showing all changes and repair can you directly nail hardwood flooring to a concrete slab - no you should never nail it directly interior carpet should be installed with - tackless strips 2 Katelyn Whitman, All Rights Reserved © 2025 before applying latex paint to the surface of an oil paint on wood trim which procedure is appropriate - wash with tsp handicap sinks should have what kind of drains - wrapped handicap restrooms should have - a min of 48" maneuverable space in front of toilet lever handles on faucet wrapped drain lines an MSDS should be kept at - jobsite a stove unit without insulation must be how many inches away from combustible material? - 6" a tee-wye is a - plumbing fitting when screw are used instead of nails. the required spacing between screws is usually - larger where is a 4-prong outlet plug used - at the service to house trailer or RV vehicle 3 Katelyn Whitman, All Rights Reserved © 2025 the function of a waler is - horizontal member used to align and brace concrete forms or piles what should you do after discovering asbestos on the job - contact chief of DOSH what is the best method for installing ceramic tiles - on cement board with thinnest adhesive in a commercial or publicly funded building which is required when a handicap sink is open underneath - surface no higher than 34" knee clearance of at least 30" no sharp edge underneath when must the contractor provide the warranty for a water heater to the property owner - on completion of installation at the job site what is the proper order of construction f