ASE BRAKES Exam #4 | 2024-2025 LATEST UPDATED| COMPLETE
QUESTIONS WITH 100% CORRECT ANSWERS| GET IT CORRECT!!
B - (answers)Four channel ABS sensors will have how many ABS wheel speed sensors?
A. Two
B. Four
C. Six
D. Eight
A - (answers)The metering valve:
A. Limits front brake application until the rear brakes apply.
B. Limits rear brake application until the front brakes apply.
C. Limits front brake application based on vehicle height.
D. Limits rear brake application based on vehicle height.
A - (answers)A wheel cylinder has been honed. It should be cleaned with:
A. Alcohol.
B. Mineral spirits.
C. Penetrating solvent.
D. Rust preventive.
B - (answers)A vehicle is equipped with a disc/drum brake system. When the customer pulls the parking brake
lever the lever travels it's full range of motion, but the parking brake does not apply. Technician A says the disc
brakes could be out of adjustment. Technician B says the drum brakes could be out of adjustment. Who is correct?
A. A
B. B
C. Both A and B
D. Neither A nor B
C - (answers)A height sensing proportioning valve would be located on:
A. The left front.
B. The right front.
C. The rear in the center.
, D. Only on all wheel drive vehicles.
D - (answers)The customer feels a rapid pedal pulsation under normal braking conditions. This could be caused by
all of the following EXCEPT:
A. Different size tires.
B. A damaged reluctor wheel.
C. Excessive reluctor to sensor gap.
D. Open circuit to the speed sensor.
B - (answers)The technician measures the front rotors; the results are listed below:
Minimum Rotor Thickness, Specifications:
.898" (22.80mm)
Actual Rotor Thickness, Left: .889" (22.58mm)
Actual Rotor Thickness, Right: .809" (25.12mm)
Which of the following should be done?
A. Replace the left rotor.
B. Replace both rotors.
C. Reuse both rotors.
D. Replace the right rotor.
C - (answers)Technician A says the primary show goes toward the front of the vehicle. Technician B says the
secondary shoe goes toward the rear of the vehicle. Who is right?
A. A
B. B
C. Both A and B
D. Neither A nor B
D - (answers)Which of the following would most commonly be used as the drive axle retaining nut on a front wheel
drive vehicle?
A. Self-locking nylon insert nut .
B. Plain hex nut without a locking feature.
C. Double nuts with a lock between them.
QUESTIONS WITH 100% CORRECT ANSWERS| GET IT CORRECT!!
B - (answers)Four channel ABS sensors will have how many ABS wheel speed sensors?
A. Two
B. Four
C. Six
D. Eight
A - (answers)The metering valve:
A. Limits front brake application until the rear brakes apply.
B. Limits rear brake application until the front brakes apply.
C. Limits front brake application based on vehicle height.
D. Limits rear brake application based on vehicle height.
A - (answers)A wheel cylinder has been honed. It should be cleaned with:
A. Alcohol.
B. Mineral spirits.
C. Penetrating solvent.
D. Rust preventive.
B - (answers)A vehicle is equipped with a disc/drum brake system. When the customer pulls the parking brake
lever the lever travels it's full range of motion, but the parking brake does not apply. Technician A says the disc
brakes could be out of adjustment. Technician B says the drum brakes could be out of adjustment. Who is correct?
A. A
B. B
C. Both A and B
D. Neither A nor B
C - (answers)A height sensing proportioning valve would be located on:
A. The left front.
B. The right front.
C. The rear in the center.
, D. Only on all wheel drive vehicles.
D - (answers)The customer feels a rapid pedal pulsation under normal braking conditions. This could be caused by
all of the following EXCEPT:
A. Different size tires.
B. A damaged reluctor wheel.
C. Excessive reluctor to sensor gap.
D. Open circuit to the speed sensor.
B - (answers)The technician measures the front rotors; the results are listed below:
Minimum Rotor Thickness, Specifications:
.898" (22.80mm)
Actual Rotor Thickness, Left: .889" (22.58mm)
Actual Rotor Thickness, Right: .809" (25.12mm)
Which of the following should be done?
A. Replace the left rotor.
B. Replace both rotors.
C. Reuse both rotors.
D. Replace the right rotor.
C - (answers)Technician A says the primary show goes toward the front of the vehicle. Technician B says the
secondary shoe goes toward the rear of the vehicle. Who is right?
A. A
B. B
C. Both A and B
D. Neither A nor B
D - (answers)Which of the following would most commonly be used as the drive axle retaining nut on a front wheel
drive vehicle?
A. Self-locking nylon insert nut .
B. Plain hex nut without a locking feature.
C. Double nuts with a lock between them.
