3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
Florida Fire Inspector (2025) comprehensive
questions and verified detailed solution|100%
CORRECT!!
Save
Terms in this set (666)
Is a single-stage pump designed to fit into the
Vertical Inline intake/discharge line with the driver located above
the inline impeller.
Fire rated walls are examples of fire protection
Passive
features.
Used to show the relative What is an exploded Pictorial Drawing?
position of parts or
construction detail, used
to clarify assembly.
One unavoidable problem with standpipe systems is
pressure
the variation of (Blank) with building height.
Descriptive Codes Traditional fire and building codes are called?
Contour lines that are close together on a plan
A steep slope
indicate.
At what height can water be effectively pumped
300 ft
from the ground level with adequate pressure?
A set of architectural drawings must contain an
architect's (Blank) signature to be considered a valid set of
plans.
A (Blank) is a collection or body of rules pertaining
code to one subject area such as buildings, fires, and
motor vehicles.
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 1/52
,3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
Fire codes typically address membrane structures
Less than 180 days
with a life of how many days?
In the welding schedule Where are the notes placed for a welding symbol?
Buildings constructed without final occupancy in
Spec Buildings
mind are called?
A (Blank) plan shows the overall project layout
plot including features such as building areas, location,
setbacks, etc.
What term is used to define the final set of plans or
As-built plans
drawings that are saved as a permanent record?
Contemporary Sprinkler systems are designed using
hydraulic
(Blank) calculations.
Mechanical What type of plan would a HVAC system be shown?
(Pressure Relieving Valve) What is the purpose of a PRV?
Device designed to limit
the standpipe pressure
for 2 1/2 inch outlets
when the pressure
exceeds 175 PSI
Run Wiring is sometime referred to as a (Blank)?
It is common for codes to require a (Blank) fire-
1 hour resistive rating for corridor walls in health care
facilities.
Any load that is applied at one point or over a small
concentrated load. area such as a safe or heavy piece of equipment is
considered a (Blank)
True or Flase, Fire and emergency service plans
True examiner may not be involved in the review of
structural plans.
What type of occupancy is considered those in
which the quantity or combustibility of the contents
Light Hazard
is low and heat-release rates expected are also
low?
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 2/52
,3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
Any effect that a structure must be designed to
load
prevent is best described as a (Blank)?
(Blank) plans show where plumbing systems and
Mechanical
heating, ventilation and air conditioning systems.
*The purpose of the (Blank) beneath the foundation
footings
is to distribute the buildings weight.
What type of force is produced in a structural
Torsional member when it is twisted, creating shear stresses in
the material?
What type of load would the impact of wind against
Direct Pressure Load
a buildings wall is known as?
An alarm system where each part of the system has
Addressable its own unique address and talks to the main control
panel is known as?
What is the maximum travel distance from any point
75 ft
in a structure to an extinguisher location?
What type of drawing provides the most realistic
Pictorial or Rendering view of how equipment looks as well as how it is
connected?
Fire alarms are required to have emergency power
systems that may consist of storage batteries or a
combination of an emergency generator and
5 min
storage batteries. When an emergency generator is
used, storage batteries capable of supplying the fire
alarm system for?
(Blank) is a term generally applied to vertical supply
Risers
pipes used to supply water to the upper floors.
Class 1 standpipe connections must be located in
Stairwells
what part of the building?
What is the term used to describe equalizing static
Grounding
electrical charge between an object and the earth?
An (Blank) indicates where an alarm or other
annunciator panel
condition has originated on the fire alarm system.
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 3/52
, 3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
*What class of standpipe is designed for use by
Class 2 either fire department personnel or building
occupants?
NFPA 14 requires a minimum residual pressure of
100 psi (Blank) psi at the most remote 2 1/2 " hose valve for
Class I and Class III standpipes.
What term is used to describe equalizing static
Bonding electrical charges between two object such as a
drum and container?
Modern elevators that rise more than (Blank) feet
25 ft are required to be equipped with a key operated
manual recall or fireman's service systems.
PRV (Pressure Relief Valve) devices typically limit the
175 psi system pressure to a maximum of (Blank) psi to
prevent damage to the system.
In high-rise structures, what is the minimum fire
2 hrs or 50 ft from the
protection rating/separation for an indoor stationary
building
fire-pump?
Gauges not accurate to within (Blank) percent of the
3%
full scale shall be recalibrated or replaced.
A method to indicate the elevation of carious
datum building features above an established reference
point is normally called a (Blank)?
To protect the The most fundamental reason for requiring
communities. health & construction permits is?
safety
(Blank) on water supplies to fire protection systems
is required to prevent potential contamination of
Backflow prevention
domestic water by cross-connection to a non-
domestic source.
An easement is the right or privilege of one party to
use the property of another for a specific and
Public Utility Easement
limited purpose. One of the most common
easement uses is the?
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 4/52
Florida Fire Inspector (2025) comprehensive
questions and verified detailed solution|100%
CORRECT!!
Save
Terms in this set (666)
Is a single-stage pump designed to fit into the
Vertical Inline intake/discharge line with the driver located above
the inline impeller.
Fire rated walls are examples of fire protection
Passive
features.
Used to show the relative What is an exploded Pictorial Drawing?
position of parts or
construction detail, used
to clarify assembly.
One unavoidable problem with standpipe systems is
pressure
the variation of (Blank) with building height.
Descriptive Codes Traditional fire and building codes are called?
Contour lines that are close together on a plan
A steep slope
indicate.
At what height can water be effectively pumped
300 ft
from the ground level with adequate pressure?
A set of architectural drawings must contain an
architect's (Blank) signature to be considered a valid set of
plans.
A (Blank) is a collection or body of rules pertaining
code to one subject area such as buildings, fires, and
motor vehicles.
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 1/52
,3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
Fire codes typically address membrane structures
Less than 180 days
with a life of how many days?
In the welding schedule Where are the notes placed for a welding symbol?
Buildings constructed without final occupancy in
Spec Buildings
mind are called?
A (Blank) plan shows the overall project layout
plot including features such as building areas, location,
setbacks, etc.
What term is used to define the final set of plans or
As-built plans
drawings that are saved as a permanent record?
Contemporary Sprinkler systems are designed using
hydraulic
(Blank) calculations.
Mechanical What type of plan would a HVAC system be shown?
(Pressure Relieving Valve) What is the purpose of a PRV?
Device designed to limit
the standpipe pressure
for 2 1/2 inch outlets
when the pressure
exceeds 175 PSI
Run Wiring is sometime referred to as a (Blank)?
It is common for codes to require a (Blank) fire-
1 hour resistive rating for corridor walls in health care
facilities.
Any load that is applied at one point or over a small
concentrated load. area such as a safe or heavy piece of equipment is
considered a (Blank)
True or Flase, Fire and emergency service plans
True examiner may not be involved in the review of
structural plans.
What type of occupancy is considered those in
which the quantity or combustibility of the contents
Light Hazard
is low and heat-release rates expected are also
low?
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 2/52
,3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
Any effect that a structure must be designed to
load
prevent is best described as a (Blank)?
(Blank) plans show where plumbing systems and
Mechanical
heating, ventilation and air conditioning systems.
*The purpose of the (Blank) beneath the foundation
footings
is to distribute the buildings weight.
What type of force is produced in a structural
Torsional member when it is twisted, creating shear stresses in
the material?
What type of load would the impact of wind against
Direct Pressure Load
a buildings wall is known as?
An alarm system where each part of the system has
Addressable its own unique address and talks to the main control
panel is known as?
What is the maximum travel distance from any point
75 ft
in a structure to an extinguisher location?
What type of drawing provides the most realistic
Pictorial or Rendering view of how equipment looks as well as how it is
connected?
Fire alarms are required to have emergency power
systems that may consist of storage batteries or a
combination of an emergency generator and
5 min
storage batteries. When an emergency generator is
used, storage batteries capable of supplying the fire
alarm system for?
(Blank) is a term generally applied to vertical supply
Risers
pipes used to supply water to the upper floors.
Class 1 standpipe connections must be located in
Stairwells
what part of the building?
What is the term used to describe equalizing static
Grounding
electrical charge between an object and the earth?
An (Blank) indicates where an alarm or other
annunciator panel
condition has originated on the fire alarm system.
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 3/52
, 3/12/25, 8:17 AM Florida Fire Inspector (2025) comprehensive questions and verified detailed solution|100% CORRECT!! Flashcards | Quizlet
*What class of standpipe is designed for use by
Class 2 either fire department personnel or building
occupants?
NFPA 14 requires a minimum residual pressure of
100 psi (Blank) psi at the most remote 2 1/2 " hose valve for
Class I and Class III standpipes.
What term is used to describe equalizing static
Bonding electrical charges between two object such as a
drum and container?
Modern elevators that rise more than (Blank) feet
25 ft are required to be equipped with a key operated
manual recall or fireman's service systems.
PRV (Pressure Relief Valve) devices typically limit the
175 psi system pressure to a maximum of (Blank) psi to
prevent damage to the system.
In high-rise structures, what is the minimum fire
2 hrs or 50 ft from the
protection rating/separation for an indoor stationary
building
fire-pump?
Gauges not accurate to within (Blank) percent of the
3%
full scale shall be recalibrated or replaced.
A method to indicate the elevation of carious
datum building features above an established reference
point is normally called a (Blank)?
To protect the The most fundamental reason for requiring
communities. health & construction permits is?
safety
(Blank) on water supplies to fire protection systems
is required to prevent potential contamination of
Backflow prevention
domestic water by cross-connection to a non-
domestic source.
An easement is the right or privilege of one party to
use the property of another for a specific and
Public Utility Easement
limited purpose. One of the most common
easement uses is the?
https://quizlet.com/1017202453/florida-fire-inspector-2025-comprehensive-questions-and-verified-detailed-solution100-correct-flash-cards/?new 4/52
