DANTE LEVEL 3 EXAM 2025| ALL QUESTIONS AND
CORRECT ANSWERS | GRADED A+ | VERIFIED
ANSWERS | LATEST VERSION
After setting up the network, you open Dante controller. You notice that one
device's name appears in Dante Controller, but other control and status
information is not available. What is the likely cause of this issue? ---------
CORRECT ANSWER-----------------Device is in a different IP subnet than
the Dante Controller computer.
What is the key aim of a network service? ---------CORRECT ANSWER------
-----------Interoperability
QoS protects against too much bandwidth being used on a link by a
collection of systems. Even if the overload happens over an extended
period of time, packets are delivered in a timely manner, regardless of their
QoS priority queue. ---------CORRECT ANSWER-----------------FALSE
Higher link speeds allow frames to be cleared quicker through an interface.
---------CORRECT ANSWER-----------------TRUE
A reply to ARP whohas message is ---------CORRECT ANSWER--------------
---Unicast
Switches look at ---------CORRECT ANSWER-----------------Destination MAC
addresses to forward frames
, Based on what we know about different transmission methods, which type
of traffic would we expect to find on the public internet? ---------CORRECT
ANSWER-----------------Unicast
Key resource considerations for a successful Dante network should
address network infrastructure and the Dante hardware for the project.
Designers should consider: (select all that apply) ---------CORRECT
ANSWER------------------Enough bandwidth within the switch
-Enough Tx flows in Dante devices
-Enough Rx flows in Dante devices
-Enough bandwidth on trunk lines
A VLAN tag is part of the 802.1 header at layer .... ---------CORRECT
ANSWER-----------------2
On a Unicast transmission, a transmitter and receiver have latency settings
of 4msec and 2msec, respectively. When will the audio playout of the
receiving device? ---------CORRECT ANSWER-----------------4 milli second
Requirements of Dante are completely satisfied by a COTS (Commercial
Off The Shelf) infrastructure ---------CORRECT ANSWER-----------------
TRUE
If two different devices try to transmit to a common device at the same
time, switches suffer from a problem in the collision domain. The packets
are not readable and, in effect, dropped. The original transmitters each wait
a random amount of time to retransmit in hopes of having a clear path. This
is a common problem in modern network switches. ---------CORRECT
ANSWER-----------------FALSE
CORRECT ANSWERS | GRADED A+ | VERIFIED
ANSWERS | LATEST VERSION
After setting up the network, you open Dante controller. You notice that one
device's name appears in Dante Controller, but other control and status
information is not available. What is the likely cause of this issue? ---------
CORRECT ANSWER-----------------Device is in a different IP subnet than
the Dante Controller computer.
What is the key aim of a network service? ---------CORRECT ANSWER------
-----------Interoperability
QoS protects against too much bandwidth being used on a link by a
collection of systems. Even if the overload happens over an extended
period of time, packets are delivered in a timely manner, regardless of their
QoS priority queue. ---------CORRECT ANSWER-----------------FALSE
Higher link speeds allow frames to be cleared quicker through an interface.
---------CORRECT ANSWER-----------------TRUE
A reply to ARP whohas message is ---------CORRECT ANSWER--------------
---Unicast
Switches look at ---------CORRECT ANSWER-----------------Destination MAC
addresses to forward frames
, Based on what we know about different transmission methods, which type
of traffic would we expect to find on the public internet? ---------CORRECT
ANSWER-----------------Unicast
Key resource considerations for a successful Dante network should
address network infrastructure and the Dante hardware for the project.
Designers should consider: (select all that apply) ---------CORRECT
ANSWER------------------Enough bandwidth within the switch
-Enough Tx flows in Dante devices
-Enough Rx flows in Dante devices
-Enough bandwidth on trunk lines
A VLAN tag is part of the 802.1 header at layer .... ---------CORRECT
ANSWER-----------------2
On a Unicast transmission, a transmitter and receiver have latency settings
of 4msec and 2msec, respectively. When will the audio playout of the
receiving device? ---------CORRECT ANSWER-----------------4 milli second
Requirements of Dante are completely satisfied by a COTS (Commercial
Off The Shelf) infrastructure ---------CORRECT ANSWER-----------------
TRUE
If two different devices try to transmit to a common device at the same
time, switches suffer from a problem in the collision domain. The packets
are not readable and, in effect, dropped. The original transmitters each wait
a random amount of time to retransmit in hopes of having a clear path. This
is a common problem in modern network switches. ---------CORRECT
ANSWER-----------------FALSE
